Amana WS900E Installation Instruction
RECOGNIZE THIS SYMBOL AS A SAFETY PRECAUTION
Table of Contents
KIT ACCESSORIES .................................................................................................... 2
D
RAIN
K
IT
....................................................................................................... 2
S
UBBASE
, L
EVELING
L
EGS
, M
AIN
D
UCT
,
AND
H
YDRONIC
H
EAT
K
ITS
.............................. 2
PRE-INSTALLATION CONSIDERATIONS ................................................................. 3
O
UTDOOR
E
NCLOSURE
P
ANEL
R
EMOVAL
................................................................. 3
WALL SLEEVE INSTALLATION .................................................................................. 4
When 230/208 volt units are to be installed, the power
supply may be either cord connected or permanent
wiring. Permanent wiring may be done through the
accessory hard wire junction box, or the accessory
subbase.
supply may be either cord connected or permanent
wiring. Permanent wiring may be done through the
accessory hard wire junction box, or the accessory
subbase.
When 265 volt units are to be installed, the permanent
wiring must be used for the power supply. Permanent
wiring can be done through the accessory hard wire
junction box, or the accessory subbase. An exposed
cord connection on 265 volt units is not permitted.
wiring must be used for the power supply. Permanent
wiring can be done through the accessory hard wire
junction box, or the accessory subbase. An exposed
cord connection on 265 volt units is not permitted.
The subbase accessory includes leveling legs. If added
wall sleeve support is required and the subbase is not to
be used, an accessory leveling leg kit may be installed.
wall sleeve support is required and the subbase is not to
be used, an accessory leveling leg kit may be installed.
PTAC
E
XTENDED
W
ALL
S
LEEVE
I
NSTALLATION
I
NSTRUCTIONS
Install before the air conditioner or heat pump chassis is set in place.
READ THESE INSTRUCTIONS THOROUGHLY BEFORE PROCEEDING.
ATTENTION INSTALLING PERSONNEL
As a professional installer you have an obligation to know the product better than the customer. This
includes all safety precautions and related items.
Prior to actual installation, thoroughly familiarize yourself with this Instruction Manual. Pay special
attention to all safety warnings. Often during installation or repair it is possible to place yourself in a
position which is more hazardous than when the unit is in operation.
Remember, it is your responsibility to install the product safely and to know it well enough to be able to
instruct a customer in its safe use.
Safety is a matter of common sense...a matter of thinking before acting. Most dealers have a list of
specific good safety practices...follow them.
The precautions listed in this Installation Manual are intended as supplemental to existing practices.
However, if there is a direct conflict between existing practices and the content of this manual, the
precautions listed here take precedence.
Part No. 20491501
Printed in USA
Printed in USA
September 2004