Monogram ZDP486NDPSS Installation Instruction

Check to be sure that burner heads and caps 
are securely seated. 

•Check for proper ignition:

– Push in one control knob and turn to LITE

position.

– The igniter will spark and the burner will light; 

the igniter will cease sparking when the burner 
is lit.

– First test may require some time, while air 

is flushed out of the gas line.

– Turn knob to OFF.
– Repeat the procedure for each burner.

IMPORTANT: If the igniter electrodes continue 
to spark after the burners are lit, check that 
each burner component is assembled properly.
Refer to the Owner’s Manual.

•Burner flames should be blue and stable with no

yellow tips, excessive noise or lifting of the flame
from the burner. If any of these conditions exist,
check that the burner ports are not blocked. 
If one of these conditions continues, call for
service.

Place the burner grates over the burners. 
The grates should be seated and should not rock.

The griddle is secured with screws. It is designed 
to be stationary and should not be removed.

The griddle has two leveling screws beneath 
the rear flue cover that can be used to adjust 
to the desired slope. 

The two inner screws are clamping screws for
securing the griddle in place. Loosen these two
screws before leveling. Do not remove these two
screws.

The two outer screws are leveling screws. Do not
remove these two screws. They can be turned to
level the griddle or to provide a forward slope to
help grease and oils drain away from the food
being cooked. 

After leveling the griddle, hand-tighten 
the clamping screws; do not over-tighten.

Griddle Flue Cover

Clamping Screws

Leveling Screws

❑ Make sure all controls are left in the OFF position.

❑ Make sure the flow of combustion and ventilation

air to the range is unobstructed.

❑ Recheck Steps:

NOTE: The rating plate is located on the bottom 
of the control panel and is visible when the oven door
is opened. The model and serial number is behind 
the left knob and is visible when the knob is pulled off.

Burner Cap Not Properly Seated

Burner Cap Properly Seated