Monogram ZDP486NDPSS Installation Instruction

TOOLS YOU NEEDED FOR CONVERSION

CONVERT THE REGULATOR

Disconnect all electrical power at the main circuit
breaker or fuse box.

A. Remove the rear vent

trim (on ranges only)
to access the
regulator. The
Rangetop regulator is
on the left bottom
corner.

B. Shut off the gas supply by closing the manual shut-off

valve in the unit or at the wall.

C. Convert the pressure regulator:

• Unscrew the cap with plunger.
• Place your thumb against flat side of the plunger and

press down to snap the plunger out of the cap.

• Carefully look at the plunger to locate the NAT

or LP position.

• Turn the

plunger
over so
that the
desired gas
is showing
near the
bottom.

• Snap the plunger back into the cap.
• Screw the cap back onto the regulator.

CHANGE BURNER ORIFICES

INSTALLATION TIP: First remove all
orifices and then start replacing them.
This will help to prevent the possibility
that some may not be replaced.
A. Remove the burner grates,

burner caps and burner heads.

B. Loosen the top burner

orifices using a 7 mm
nut driver. Use small
pliers to carefully lift out the orifices.
The main orifice is located
low in the center of the
burner, while the simmer
orifice is located higher
beside the center
of the burner.

DOWN

FOR OFF

NAT

Gasket

Cap

Plunger

LP Position

NAT. Position

Pressure Regulator

Burner Cap

Burner

Head

Spark

Igniter

Simmer
Orifice

Main
Orifice

WARNING:

This conversion must

be performed by a qualified installer or gas supplier
in accordance with the manufacturer’s instructions
and all codes and requirements of the authority having
jurisdiction. Failure to follow instructions could result
in serious injury or property damage. The qualified
agency performing this work assumes responsibility
for the conversion.

WARNING:

The rangetop, as shipped from

the factory, is set for use with its intended gas. If you
wish to use your rangetop with the alternate gas, you
must first replace the orifices and convert the pressure
regulator.

WARNING:

The following adjustments must

be made before turning on the burner. Failure to do so
could result in serious injury. Be sure pressure regulator
has been converted as described in Step 2.

Safety Glasses

Small Flat-Head Screwdriver

(2 to 2.4 mm or 3/32” tip size,

60 mm long)

Crescent Wrench

1/4” and 7mm Nutdrivers

Installation

Convert Natural Gas to LP Gas Operation

Instructions

Convert LP Gas to Natural Gas Operation

Small Pliers

1/2” Deepwell

Socket Wrench

Philips

Screwdriver

ORIFICE HOLDER

The range orifice holder
is located behind the front
access panel at the bottom
of the range.
The rangetop orifice holder
is located inside the range insulation cover.
Additional orifices may be present. Use only the orifices
specified in the instructions for your range or rangetop.

Burner Base

Griddle

Orifice

Grill

Orifice

Burner Orifices

Range Regulator