Monogram ZV1050SFSS Manual

7

Care and Cleaning

Before servicing or cleaning unit, switch power
off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the
service disconnecting means cannot be locked,
securely fasten a prominent warning device,
such as a tag, to the service panel.

Avant de réparer ou de nettoyer votre appareil,
débranchez le courant au niveau du panneau
de service et verrouillez les mécanismes de
débranchement de service pour éviter tout
branchement accidentel au courant. Si vous 
ne pouvez pas verrouiller les mécanismes 
de débranchement de service, attachez
soigneusement un avertissement bien visible,
comme une étiquette, au panneau de service.

Remove the trim ring by turning it
counterclockwise.

Grasp the bulb on the edges and 
pull it straight out.

Replace with the same size bulb.

These 12 volt, 20 watt halogen bulbs 
are available at specialty lighting stores. 
Ask for GE bulb or equivalent:
Q20MR16/C/CG40–BAB.

Clean the grease filter after 30 hours of “on” time.
A red signal light will alert you when 30 hours 
has passed.

Remove the grease filters and wash them 
either by hand or in the dishwasher using 
non-abrasive soap.

To clean, swish the filters in hot soapy water 
or wash them in the dishwasher. Do not use
abrasive cleansers.

Replace the filters and make sure that they are
correctly seated in the filter channels. Adjust as
necessary until the red signal light stops blinking.

To clean the stainless steel surface, use warm 
sudsy water or a stainless steel cleaner or polish.
Always wipe the surface in the direction of the
grain. Follow the cleaner instructions for 
cleaning the stainless steel surface.

To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the location
of a dealer nearest you, please call our toll-free
number:

NOTE: To remove filters,
push them back and
down using the knob.

Front

For proper operation, make
sure the filters are securely

seated into the channels.

On some models, the lights are

located on the front and back, 

on the underside of the hood.

On some models, the lights 

are located on the sides, 

on the underside of the hood.