Monogram ZV1050SFSS Installation Instruction

• Align the template with the marks on the ceiling and

tape in place.
– Be sure the template is oriented correctly, with the

front of the hood.

• Use a plumb bob to be sure the mounting holes will

provide parallel alignment with the countertop below.

• Center punch all hole locations.
• Drill pilot holes in the 4 screw locations. Use a 5/32"

bit and drill approximately 1-1/2" deep.

• Cut the 8-1/4" duct opening and approx. 1" wire

access hole.

Install upper support frame
• Secure the upper support frame to the ceiling joists

and cross framing with the 4 lag screws provided. For
maximum rigidity and strength, the screws must be
driven into the center of the joists and/or cross
framing.

Install lower support frame
• Insert lower support frame (or accessory support

frame, ZX1059SFSS or ZX10510SFSS) into the upper
support frame and loosely secure with 8 screws and
washers (4 on the front and 4 on the back sides).

• Adjust the lower support frame up or down to the

desired height above the countertop. Tighten screws.

Again, check to be sure the support

is level in both directions. There is no way to level
the hood after the hood is secured to the frame.

30" Recommended

10"

40"

Countertop

Hood 
Mounting
Flange

Lower Support

76"

Wire Access Holes

Support 

Frame

Opening

Upper 

Support

Frame

Lower 

Support

Frame

Check Level in

Both Directions

Front

Of 

Hood