Monogram ZV1050SFSS Installation Instruction

 If house wiring is not 2-wire

with a ground wire, a ground must be provided by the
installer. When house wiring is aluminum, be sure
to use UL approved anti-oxidant compound and
aluminum-to-copper connectors.

Si le câblage

de la maison n’est pas du type à deux fils avec un fil
de terre, l’installateur doit fournir un circuit de terre.
Quand les fils de la maison sont en aluminium,
il prendre soin d’utiliser de la pâte antioxidation
approuvée par UL et des connecteurs pour
l’aluminium-cuivre.

• Install strain relief onto the knockout of the junction

box cover.

• Insert house wiring through strain relief and tighten.
• Connect white leads to branch circuit white lead.
• Connect black leads to branch circuit black lead.
• Connect green/yellow leads to branch circuit green

or bare ground lead.

• Secure all connections with wire nuts on each

electrical connector.

• Push wires into junction box and replace cover.

Be sure wires are not pinched.

• Hold the decorative duct cover and remove the

decorative stop screw from the support frame.
Keep the screw.

• Slide the lower duct cover down onto the hood.
• Install the decorative screw in the lower left hole on

the duct cover as shown.

Install

Decorative

Screw