Bosch B26FT70SNS Installation Instruction
en-us
25
Problem
Corrective action
Possible cause
Water droplets are
forming inside the
appliance.
forming inside the
appliance.
Humidity is too high or doors have been
opened frequently.
opened frequently.
Do not open doors as frequently or do not keep
them open too long.
them open too long.
The door seals are not tight.
Check the door seals and foldaway door bar; if
necessary, clean or correct position.
necessary, clean or correct position.
Drawers can only be
closed with great
difficulty.
closed with great
difficulty.
The drawer has not been inserted correctly.
Insert the drawer correctly.
The drawer rails are dirty.
Clean the drawer rails.
Ice and water dispenser
Problem
Possible cause
Corrective action
The water filter symbol
is flashing.
is flashing.
The filter cartridge is old.
Replace the filter cartridge.
After replacing the filter cartridge, the water
filter symbol was not reset.
filter symbol was not reset.
Reset the water filter symbol.
The ice maker is not
making enough ice
cubes or the ice cubes
are deformed.
making enough ice
cubes or the ice cubes
are deformed.
The appliance or ice maker was just recently
switched on.
switched on.
It takes approx. 24 hours before it starts making
ice.
ice.
A large amount of ice has been taken out.
It takes approx. 24 hours before the ice storage
bin is full again.
bin is full again.
Water pressure is too low.
Have the water pressure checked.
The filter cartridge is clogged or old.
Replace the filter cartridge.
The ice maker is not
making enough ice
cubes or any ice cubes
at all.
making enough ice
cubes or any ice cubes
at all.
An ice cube is jammed on the arm that
measures the level of the ice cube container.
measures the level of the ice cube container.
Remove the ice cube container and release the
jammed ice cubes with a blunt plastic tool. Do
not use sharp or pointy objects as this could
damage the appliance.
jammed ice cubes with a blunt plastic tool. Do
not use sharp or pointy objects as this could
damage the appliance.
When switching from ice cubes to crushed
ice, an ice cube may become jammed inside
the dispenser opening. The ice cube will
begin to melt and water will drip into the ice
and water dispenser.
ice, an ice cube may become jammed inside
the dispenser opening. The ice cube will
begin to melt and water will drip into the ice
and water dispenser.
Release the jammed ice cube from the
dispenser opening using a blunt plastic tool. Do
not use sharp or pointy objects as this could
damage the appliance.
dispenser opening using a blunt plastic tool. Do
not use sharp or pointy objects as this could
damage the appliance.
There is a layer of ice on the screw
conveyor.
conveyor.
Remove and clean the ice cube container.
The ice cube container
contains ice cubes that
are not being
dispensed.
contains ice cubes that
are not being
dispensed.
Ice cubes are frozen to one another.
Remove and clean the ice cube container.
The ice maker is not
making ice cubes.
making ice cubes.
The ice maker is switched off.
Switch on the ice maker.
The appliance is not being supplied with
water.
water.
Have a qualified technician check the water
connection.
connection.
The water connection line has kinks in it.
Shut off the water supply. Straighten out the
kinks. Have damaged water connection lines
replaced with original manufacturer parts.
kinks. Have damaged water connection lines
replaced with original manufacturer parts.
Water pressure is too low.
Have the water pressure checked.
The ice cube container is not inserted
correctly.
correctly.
Insert the ice cube container correctly.
The water connection is installed incorrectly.
If the water connection is not installed correctly,
this can cause low water pressure and can
damage the appliance.
this can cause low water pressure and can
damage the appliance.