Viking VCSB5483WH Installation Instruction

23

Headline

23

 General Information

  Area Requirements

 •  Most of the unit’s weight is at the top.  
  Extra care is needed when moving the unit  
  to prevent tipping. 

•  DO NOT remove protective fi lm until unit  
  is in operating position. 

•  All four leveling legs must contact the fl oor  
  to support and stabilize the full weight. 

•  DO NOT drop unit.

•  Remove exterior shipping materials prior  
  to moving unit into home, except door  
 latching 

device.

•  Use two or more people to move and  
  install unit. Failure to follow this instruction  
  can result in back or other injury. 

•  To avoid personal injury, wear gloves when  
  performing any installation procedure  and  
  wear eye protection when cutting metal  
 straps.

Tip Over Hazard

Appliance is top heavy and tips easily when 
not completely installed. Keep doors closed 
until appliance is completely installed and 
secured per installation instructions. Use 
two or more people to move and install
appliance. Failure to do so can result in 
death or serious injury.

Unpacking Unit 

1.   Remove top and bottom strap.

2.   Remove top cap.

3.   Cut carton rear approximately 1/4” 
 

(0.6 cm) to 1” (2.5 cm) from right corner  

 

with a utility knife extended 1/4” (0.6 cm).

4.   Remove carton and exterior packaging.  
 

Save cardboard shipping material to  

 protect 

fl oor surface when installing unit.

 

Remove anti-tip board and kickplate  

 

from rear of unit.

 Moving Unit

 Remove shipping brackets from skid by removing four 

bolts (two on each side) with a 1/2” (1.3 cm) deep-well 

socket wench and a pair of pliers. Note:  Tilting unit is 

  Slip appliance dolly between unit and skid. 

Remove unit from skid. Note:   Use excess packaging