Monogram ZET1FHSS Installation Instruction

This appliance must be supplied with the proper voltage and frequency and connected to an individual, 

properly grounded branch circuit, protected by a circuit breaker or fuse. See the rating plate located on the 

oven frame to determine the rating of the product. 

Use the chart below to determine the minimum recommended dedicated circuit protection:

DO NOT shorten the flexible conduit. The conduit strain relief clamp must be securely attached to the 

junction box and the flexible conduit must be securely attached to the clamp. If the flexible conduit will not 

fit within the clamp, do not install the oven until a clamp of the proper size is obtained.
The 3 power leads supplied with this appliance are suitable for connection to heavier gauge household 

wiring. The insulation of these 3 leads is rated for temperatures much higher than the temperature rating of 

the household wiring. The current-carrying capacity of the conductor is governed by the wire gauge and the 

temperature rating of the insulation around the wire.



”.:

”.:

$PS

  4.9 KW–7.2 KW 

4.2 KW–6.2 KW 

30 Amp

  7.3 KW–9.6 KW 

6.3 KW–8.3 KW 

40 Amp

  9.7 KW–12.0 KW 

8.4 KW–10.4 KW 

50 Amp

Rating plate 

is located on 

left side trim

Connected 

Appliance 

Information 

is located on 

right side trim

 Switch power off at the service panel and lock the service disconnecting 

means to prevent power from being switched on accidentally. When the service disconnecting means 

cannot be locked, securely fasten a prominent warning device, such as a tag,  

to the service panel.
Place oven on table or platform even with the cutout opening. For a French Door oven, the platform must 

support 220 lbs. (98.8 kg). Connect the flexible conduit to the electrical junction box as shown below*. 

Position the conduit in such a manner that it will lie behind the unit in a natural loop when the oven is 

installed. You will need to purchase an appropriate strain relief clamp to complete the connection of the 

conduit to the junction box.

* Ovens come equipped with a 40” long conduit. If a longer conduit is desired, there may be one available for 

your model. To check availability or order parts, call 1.800.GE.CARES.

Junction Box 

Conduit

Bare 

Ground

Red

White

Black

Strain Relief Clamp 

(not included) Must Be 

Used at Junction Box

Place Oven on a 

Support to Assist in 

Connecting Conduit

Ground 

Wire