Monogram ZIFS360NXRH Manual

16

Anti-Tip Bracket Installation

• The kit supplied with the unit contains 2 lag

bolts and 4 toggles with bolts. The wall bracket
will be attached to the wall in 4 places.

• Measure the opening where the unit is to be

installed. Mark the center with a vertical line.

• Measure up 81 1/2" from the floor. Mark this

point on the wall.

• Using a level, draw a horizontal line on the wall 

at this height.

• Locate at least 2 studs on the back wall. 

Mark these points on the horizontal line.

• Place the bottom of the wall bracket with tabs 

on the horizontal line. Align the center notch 
on the bracket with the center line on the wall.

• The anti-tip wall bracket has a series of holes. 

Select 2 holes that match with the located
studs. Make sure the holes selected are 
on the center of the studs. Mark the wall 
at these points.

• Mark an additional hole at each end 

of the bracket. If one of the studs is closer 
to the end of the bracket, mark an additional
hole towards the center of the bracket.

• Drill 1/2" holes into the wall board 

at the locations marked for the toggles 
to be mounted (not the stud markings).

• Drill 3/16" holes into wooden studs where

marked. If steel stud construction, drill 1/2"
holes into the studs where marked. You will 
use 2 toggles with the metal studs.

Two Additional 

Hole Locations at 

Ends of Brackets

Center

Wall Bracket

Line On Wall

Wall Studs

Line on Wall

Center