Amana EDK02B Installation Instruction
3
MDK Installation Instructions
1.
If the cabinet front is screwed to the chassis, remove
the screw located behind the inlet grille. Pull the inlet
grille forward from the top of the grille to access two
screws.
the screw located behind the inlet grille. Pull the inlet
grille forward from the top of the grille to access two
screws.
2.
Remove cabinet front from chassis by tilting the bot-
tom of the front forward, lifting slightly up and forward.
tom of the front forward, lifting slightly up and forward.
3.
Disengage discharge grille from cabinet front by re-
moving four pal nuts from under the front
moving four pal nuts from under the front
FRONT MOUNTING
HOLE
Cabinet Front Removal
WARNING
To avoid the risk of personal injury or death due to electrical shock,
disconnect power
source before removing the chassis.
4.
Place transition in air discharge opening of cabinet
front and secure with the provided U-clip.
front and secure with the provided U-clip.
5.
Using 1/8” drill bit, pre-drill holes in front using the ac-
tual transition as a template. Fasten with three
screws. Do not overtighten.
tual transition as a template. Fasten with three
screws. Do not overtighten.
P
RE
-A
SSEMBLY
[T
RANSITION
/F
RONT
]
TRANSITION
AIR DISCHARGE
OPENING
OPENING
CABINET
FRONT
FRONT
`
U-CLIP
Transition Assembly