BlueStar BWO36AGS Installation Instruction

                     P/N 750323 Page   23 

 

All specifications are subject to change without prior notification.

 

 



As part of installation protective plastic 
wrappers on stainless steel surfaces 
should be removed.  These wrappers 
must be removed before operation. 



New appliances are wiped clean with 
various cleaners and solvents to remove 
visible signs of dirt, oil and grease be-
fore leaving the factory. 



Before turning on your oven for the first 
time, remove the broiler pan, oven 
racks, and rack guides and wash them 
with hot soapy water.  Thoroughly rinse 
and dry items and replace them. 



During initial start-up, after all perform-
ance checks and adjustments, the oven 
should be allowed to heat to burn off 
any oils or solvents from internal parts. 
The presence of such coatings is normal 
as part of the manufacturing process. 



Follow the user instructions to light the 
oven.  Once lit set the temperature ad-
justment to 300º. 



Allow the oven to pre-heat at least 10 
minutes before turning on the convec-
tion fan. 



After approximately 30 minutes in-
crease the temperature setting to 450º 
and allow to heat for another hour. 



During this process a strong odor and/or 
some smoke may be observed as any 
oils and solvents on internal parts are 
burned off.  This is the primary reason 
for the burn-off process.   

 

 

Air shutter adjustments are preset at the 
factory.  These adjustments may need to be 
redone and/or fine tuned by the installer.  
These adjustments are normal.  They are 
the responsibility of the qualified installer 
and are not covered by your warranty.