U-Line 2275DWRC Instruction Manual
U-Line Insert Panel Installationl
1
1 Insert Panel Installation
Custom 1/4'' Thick Door/ Drawer Panel
Insert
Insert Panel Preparation
A custom insert panel may be inserted into the doorframe.
Custom insert panels can be flat or raised, as long as the maximum
panel thickness, where inserted into the door / drawer reveal
(channel), is no more than 1/4" thick. For raised panels, the depth
of the reveal is 1/4" on all four sides.
Custom insert panels can be flat or raised, as long as the maximum
panel thickness, where inserted into the door / drawer reveal
(channel), is no more than 1/4" thick. For raised panels, the depth
of the reveal is 1/4" on all four sides.
IMPORTANT
IMPORTANT
Raised panels will reduce the door’s 90° swing/zero
clearance if the unit is installed next to a wall or similar
type of structure.
clearance if the unit is installed next to a wall or similar
type of structure.
Panel Dimensions.
The insert panel must not weigh more than 20 lbs.
Insert Panel Installation
CAUTION
Use care when handling the insert. Insert edges may be
sharp.
sharp.
Door Models
1. Remove top hinge screw pin with
Phillips head screwdriver. Remove
door by tilting forward and lifting
off bottom hinge pin.
door by tilting forward and lifting
off bottom hinge pin.
Model
Width
Height
1115R
13 15/16”
26 15/16”
1175R
22 15/16”
16 15/16”
2115R
14 1/32”
27 11/16”
2175R
23 1/32”
27 11/16”
2275DWR
23 1/32”
12 15/32”
29R
19 13/16”
21 13/32”
ADA24R
22 15/16”
26 15/16”
BI-2115
14 1-32”
27 11/16”
BI-95
12 15/16”
13 15/32”
BI-95BTP
12 15/16”
13 15/32”
CLR2160
14 1/32”
27 11/16”
CLRCO2175
23 1/32”
27 11/16”
CO1175
22 15/16”
26 15/16
CO2175
23 1*32”
27 11/16”
CO29
19 13/16”
21 13/32”
Drawer Models
2. Drawer model inserts can be installed without removing the
drawer from the unit. Simply pull the drawer open and follow
instructions.
instructions.
3. Pull door / drawer gasket out of
groove (top edge of door /
drawer only). Start in the
middle and pull outward,
moving toward the edge . This
may take some force.
drawer only). Start in the
middle and pull outward,
moving toward the edge . This
may take some force.
3. Remove the two outside
screws holding door / drawer
handle. Slightly separate door
handle from door.
handle. Slightly separate door
handle from door.
4. Pull handle up and off.
5. Slide custom door panel insert into 1/4-inch channel in door /
drawer front.
IMPORTANT
IMPORTANT
Use care not to damage magnet, located on door bottom,
when installing door insert. Do not set door on bottom
edge when pushing insert into place.
when installing door insert. Do not set door on bottom
edge when pushing insert into place.
6. Holding door / drawer gasket out of the way, replace handle on
door, making sure it is seated properly on insert and that screw
holes line up.
holes line up.
7. Install two small screws removed in Step 3.
8. Starting at the corners and working inward, push door gasket
into place on door.
Door Models Only
9. Place door on bottom hinge pin and install upper hinge screw.