Summit SEH46 Manual
15
8
INSTALLATION
CAUTION: During installation, persons installing the hood must wear heavy gloves
CAUTION: During installation, persons installing the hood must wear heavy gloves
to protect against sharp edges.
POSITIONING THE RANGE HOOD
Upon completion of installation, the distance between the hood and an electric
rangetop must be a minimum of 25" (65cm), and the distance between the hood and a
gas rangetop must be a minimum of 30" (75cm).
Upon completion of installation, the distance between the hood and an electric
rangetop must be a minimum of 25" (65cm), and the distance between the hood and a
gas rangetop must be a minimum of 30" (75cm).
min. 30" for gas ranges
min. 25" for electric ranges
PREPARING THE SITE
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY,
OBSERVE THE FOLLOWING:
a.
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY,
OBSERVE THE FOLLOWING:
a.
Installation work and electrical wiring must be done by quali?ed personnel in
accordance with all applicable codes and standards, including ?re-rated
construction.
accordance with all applicable codes and standards, including ?re-rated
construction.
b.
Sufficient air is needed for proper combustion and exhausting of gases through
the ?ue (chimney) of fuel-burning equipment to prevent backdrafting. Follow the
range manufacturer's guidelines and safety standards such as those published by
the National Fire Protection Association (NFPA), the American Society for
Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local
code authorities.
the ?ue (chimney) of fuel-burning equipment to prevent backdrafting. Follow the
range manufacturer's guidelines and safety standards such as those published by
the National Fire Protection Association (NFPA), the American Society for
Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local
code authorities.
c.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and
other hidden utilities.
other hidden utilities.
d.
Ducted fans must always be vented to the outdoors.
WARNING!
Be sure the bulb is cool before trying to change it.
1
2
REPLACEMENT OF LIGHTING COMPONENTS
Disconnect the hood.
Remove the aluminum cassette filter.
In order to change the 50-watt halogen light bulb, refer to diagram below. (1) Press
down on the back part of the lamp holder and (2) turn it counter-clockwise.
down on the back part of the lamp holder and (2) turn it counter-clockwise.
Replace old bulb with new one. Turn in reverse direction when installing new bulb.
50-W Halogen bulb
Note: Replacement bulbs can be purchased directly from SUMMIT by calling us at
1-800-932-4267 or by going to our website at www.summitappliance.com/support.
Have the model number of your range hood handy.
1-800-932-4267 or by going to our website at www.summitappliance.com/support.
Have the model number of your range hood handy.
MOVING THE HOOD
If you expect to have to move your range hood:
*
*
Keep original packaging. Move your hood using original packaging; comply
with moving instructions printed on the packaging.
with moving instructions printed on the packaging.
If you do not have original packaging:
*
*
Do not put any load on the range hood.
*
Avoid any possible impacts.
*
Pack the hood in such a way as to prevent damage.