Monogram ZDT800SIFII Installation Instruction

• 

If using a flexible braided supply hose, label the hose 

with the installation date to use as reference. Flexible 
braided hoses should be replaced in 5 years.

• Turn off the water supply.
• Install a hand shut-off valve in an accessible location, 

such as under the sink. (Optional, but strongly 
recommended and may be required by local codes.)

• Water connection is on the left side of the dishwasher. 

Install the hot water inlet line, using no less than 3/8” 
copper tubing or a flexible braided hose. Route the line 
as shown in Figure F and extend forward at least 19” 
from rear wall. 

• Adjust water heater for 120°F to 140°F temperature.
• Flush water line to clean out debris.
• The hot water supply line pressure must be 20-120 PSI.

NOTE: GE recommends copper tubing for the water 
line, but if you choose to use flexible hose, use GE’s 
WX28X326, flexible braided hose.

•

 The water supply line (3/8” copper tubing or flexible 

braided hose) may enter from either side, rear or floor 
within the shaded area shown in Figure F.

• The water supply line may pass through the same 

hole as the electrical cable and drain hose. Or, cut an 
additional 1-1/2" diameter hole to accommodate the 
water line. If power cord with plug is used, water line 
must not pass through power cord hole.

6"

4"

Cabinet Face

Shut-off
Valve

2" From Floor

19" From Wall

2"

From

Cabinet

1-1/2" Dia.

Hole

Hot

Do not remove wood base until you are ready to install 

the dishwasher. The dishwasher will tip over when the 

door is opened if base is removed.