Monogram ZDT800SIFII Installation Instruction

STEP 9 POSITION WATER LINE AND

+286(:,5,1*

• Position water supply line and house wiring on the

floor of the opening to avoid interference with base of

dishwasher and components under dishwasher.

STEP 10 ,167$//'5$,1+26(

7+528*+&$%,1(7

• Position dishwasher in front of cabinet opening. Insert

drain hose into the hole in cabinet side. If a power cord

is used, guide the end through a separate hole.

Tip: Prevent unnecessary service call charges for fill,

drain or noise concerns.

Position utility lines so they do not interfere with anything

under or behind the dishwasher.

Dishwasher Installation

STEP 6 REMOVE FLOOR PROTECT

• Disconnect leak sensor wire
(on some models).
• Remove 2 screws from front of the

Floor Protect with a ¼” driver.

• Rotate Floor Protect outward and lift

out of the mounting tabs.
• Set aside for use in Step 22.

Floor Protect

Leak Sensor

Figure L

STEP 7 INSTALL 90° ELBOW

• Thread 90° elbow

onto the water valve.
• Do not overtighten

elbow. Water valve

bracket could bend

or water valve fitting

could break.
• Position the end of the

elbow to face the rear

of the dishwasher.

Figure M

Water Valve

Bracket

Fill Hose

Front of dishwasher

STEP 8 ,167$//'5$,1+26(72

DRAIN LOOP

Connect drain loop end to drain hose using the screw

clamp as shown in the figure.

NOTE: The high drain loop on the side of the tub is

designed for better wash performance. Do not remove

from the side of the tub.

Figure N

Figure O

Water

Line

House

Wiring

Power Cord

(If Used)

Insulation

Blanket

Water

Line

Maximum Drain Hose

Length 15'

House
Wiring

Drain

Hose

Figure P

90° Elbow

Squeeze connector at top

to release snap feature