Samsung RS27FDBTNSR User Manual
20_
setting up
ALIGNING THE HEIGHTS OF THE
REFRIGERATOR DOORS
REFRIGERATOR DOORS
If the Fridge door is lower than the Freezer door,
adjust the door height by turning the door height
adjustment bolt at the bottom of the Fridge door.
adjust the door height by turning the door height
adjustment bolt at the bottom of the Fridge door.
Height difference
• Turning it counter clockwise increases the
height of the door and turning it clockwise
decreases the height of the door.
decreases the height of the door.
• Loosen the screw (
1 ), turn the adjusting bolt
(
2 ) with a spanner to align the door height to
the Freezer door and then fix it by fastening the
screw (
screw (
1 ).
(1) Screw
(2) Adjusting bolt
• After adjusting the height, be sure to install the
protective rubber inserts as shown in the figure
to protect your feet from injury.
to protect your feet from injury.
If you increase the height of the Fridge
door by too much, the switch may be
damaged or the door may not close
properly.
door by too much, the switch may be
damaged or the door may not close
properly.
CAUTION
INSTALLING THE WATER
DISPENSER LINE
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20-125 psi (138 ~ 862 kPa) is required.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20-125 psi (138 ~ 862 kPa) is required.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼” compression nut.
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼” compression nut.
Connecting to the water supply line
1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Pipe clamp
Cold water line
Shut off valve
DA68-02935A-02.indb 20
13. 8. 28. �� 9:10