Viking RVRF336SS Use & Care Manual

11

Removing the Doors

Installing Freezer Drawer

 

1

  With lower slides pulled out, hang drawer onto slide 

brackets ensuring pins on each side are fully inserted 
into slots on each side.

CAUTION

Drawer is heavy. Use caution when lifting.

 

6

  Tighten four drawer screws.

 

7

  Recheck gasket seal.

 

8

  Install the toe grille by fi tting into place.

 

2

  Reinstall four drawer screws (two per side), tighten 

down, and close drawer (C).

Pull Drawer Out

From Both Sides

Grab Drawer

At Center

Then

Push Against

Freezer Drawer

Fully Extend  

Assembly

 

Drawer Slides

Pin

Slot

Cabinet

Drawer

Install Screws

(2) Each Side

 

3

  Check gasket seal around top, bottom, and sides of 

freezer drawer.

 

4

  If gasket is not sealed, open drawer and slightly 

loosen four drawer screws (two on each side) to allow 
drawer to rotate.

 

5

  Close drawer and recheck the seal on the gasket (A). 

Open the drawer grabbing by the sides in the center 
(B). Be careful not to rotate the drawer.

Installing the Door Handles

 

1

  There are 6 handle studs on the refrigerator.

 

2

  Slide handle endcaps over door stud.

 

3

  Tighten the set screw.  There are 2 set screws per 

handle assembly.

 

4

  Repeat with all 3 handle assemblies.