Viking RVRF336SS Use & Care Manual
7
Installation
Leveling Freezer Drawer
(if necessary)
Figure 1:
Remove screws and then gently pull forward.
1
Check gasket seal around top, bottom, and sides of
freezer drawer.
2
If gasket is not sealed, open drawer and slightly
loosen four drawer screws (two on each side) to allow
drawer to rotate (see illustration).
drawer to rotate (see illustration).
3
Close drawer and recheck the seal on the gasket (A).
Open the drawer grabbing by the sides in the center
(B). Be careful not to rotate the drawer.
(B). Be careful not to rotate the drawer.
4
Tighten four drawer screws.
5
Recheck gasket seal.
Level Refrigerator & Adjust Doors
(if
necessary)
Guidelines for fi nal positioning of your refrigerator:
• All four corners of the cabinet must rest fi rmly on the
fl oor.
• The sides should tilt
¼
inch (6 mm) from front to back
(to ensure that doors close and seal properly).
• Doors should align with each other and be level.
Most of these conditions can be met by raising or
lowering the adjustable front rollers.
lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1
Slightly open freezer drawer.
2
Remove the toe grille (following the illustrations below
for the toe grille on your model).
Pull Drawer Out
From Both Sides
Grab Drawer
At Center
Then
Push Against
Freezer Drawer
3
You can raise or lower each door. Use a
⅜
inch socket
wrench to turn the adjustment screws (one per side).
To raise:
turn adjustment screw clockwise.
To lower:
turn adjustment screw counterclockwise.
4
Ensure both doors are bind-free with their seals touching
the cabinet on all four sides and that cabinet is stable.
5
After unit is leveled, lower anti-tip leg until it contacts the
fl oor.
6
Install the toe grille by fi tting into place (replacing screws
on some models).
Remove Hex
Head drawer
Screw
Head drawer
Screw
Remove Hex
Head drawer
Screw
Head drawer
Screw
Remove Hex
Head drawer
Head drawer
Screw
Remove Hex
Head drawer
Head drawer
Screw
DO NOT REMOVE
OTHER SCREWS
OTHER SCREWS
Figure 2:
Lift the toe grille and gently pull forward.
Remove
Mounting
Screws
Shoulder
Screw
Screw
Clip
Shoulder
Screws
Toe
Grille
Raise
Lower
Anti-tip
Leg
Leg
Door
Door