Bosch B10CB80NVS Owner's Manual

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Customer service will charge you for advice  even if the appliance is still under guarantee!

 

Temperature differs greatly 

from the set value.

In some cases it is adequate to switch off 

the appliance for 5 minutes.
If the temperature is too high wait a few hours 

and check whether the temperature has 

approached the set value.
If the temperature is too low check 

the temperature again the next day.

The light does not work.

Light switch is jammed.

Check whether the light switch can move.

The light is defective.

(See chapter “Light”.)

Controls have reduced lumi-

nosity.

When the appliance is not used for 

some time, the display on the fascia 

switches to energy saving mode.

As soon as the appliance is again used, e.g. the 

door is opened, the display switches back to nor-

mal illumination.

Displays do not illuminate.

Power failure;  

the fuse has been switched off; 

the mains plug has not been 

inserted properly.

Connect mains plug. Check whether the power 

is on, check the fuses.

The temperature in 

the freezer compartment is 

too warm.

Appliance opened frequently.

Do not open the appliance unnecessarily.

The ventilation openings have been 

covered.

Remove obstacles.

Large quantities of fresh food are 

being frozen.

Do not exceed max. freezing capacity.

Freezer compartment door 

was open for a long time; 

temperature is no longer 

reached.

The evaporator (refrigeration gener-

ator) in the No Frost system is cov-

ered in thick ice and can no longer 

be defrosted fully automatically.

To defrost the evaporator, remove the frozen 

food with the compartments, insulate well and 

store in a cool location.
Switch off the appliance and move it away from 

the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins to 

run into the evaporation pan, at the rear of the 

appliance.

To prevent the evaporation pan from overflowing 

in this case, mop up the condensation with 

a sponge.
The evaporator is defrosted when the water 

stops running into the evaporation pan. Clean 

the interior. Switch the appliance back on again.