Bosch B10CB80NVS Owner's Manual

Have a technician install and connect the appliance 

according to the enclosed installation instructions.

,

WARNING: 
Do not install this appliance:

■

outdoors,

■

in an environment with dripping water,

■

in rooms where there is a risk of frost.

The appliances are heavy and must be secured during 

transportation and installation.
Because of the weight/dimensions of the appliance 

and to minimize the risk of injuries and damage 

to the appliance at least two persons are necessary 

to set-up the appliance securely.

A dry, well ventilated room is suitable as an installation 

location. The installation location should not be 

exposed to direct sunlight and not placed near a heat 

source, e.g. a cooker, radiator, etc. If installation next 

to a heat source is unavoidable, use a suitable 

insulating plate or observe the following minimum 

distances from the heat source:

■

To electric or gas cookers 1

1

/

4

” (3 cm).

■

To an oil or coal-fired cooker 11

13

/

16

” (30 cm).

The floor of the installation location must not give way; 

if required, reinforce floor. 

The air on the rear panel and on the side panels of 

the appliance heats up. Conduction of the heated air 

must not be obstructed. Otherwise the refrigeration unit 

must work harder. This increases power consumption. 

Therefore: Never cover or block ventilation openings!

After installing the appliance, wait at least 1 hour until 

the appliance starts up. During transportation the oil in 

the compressor may have flowed into the refrigeration 

system.
Before switching on the appliance for the first time, 

clean the interior of the appliance (see chapter 

“Cleaning the appliance”).

,

WARNING: 
Avoid the risk of an electric shock!

,

WARNING: 
Insert into a grounded 3-phase socket. Never 

remove grounding phase. Do not use any 

adapters. Do not use any extension cables.

,

WARNING: 
Non-compliance with these instructions may 

result in death, fire or an electric shock. 

Improper connection of the protective conductor 

may result in an electric shock. If you are in 

doubt whether the appliance has been grounded 

properly, have the appliance tested by 

a qualified electrician or service technician.

Do not use extension cables or distributors. This 

appliance must be connected to a permanently 

installed socket.
The socket must be near the appliance and also freely 

accessible following installation of the appliance.
The appliance complies with protection class I. 

Connect the appliance to 115 V/60 Hz alternating 

current via a correctly installed socket with protective 

conductor. The socket must be fused with a 10 to 16 A 

fuse.
The appliance comes with a UL registered 3-wire power 

cord. The appliance requires a 3-pole socket.
Please observe the following table with regard to this:

Check on the rating plate whether the indicated voltage 

and current type correspond with the values of your 

power supply. The location of the rating plate can be 

found in the chapter entitled Customer service.

,

WARNING: 
Never connect the appliance to electronic 

energy saver plugs.
Our appliances can be used with mains and 

sine-controlled inverters. Mains-controlled 

inverters are used for photovoltaic systems 

which are connected directly to the national grid. 

Sine-controlled inverters must be used for 

isolated applications (e.g. on ships or 

in mountain lodges) which are not connected 

directly to the national grid.

Fridge-freezer

6.0 amps