Danze D409010SS Installation Instruction

Page of 6
5. 
Install the quick connect hoses between the side of the spout tube adapter 
      and the valves. Push onto the fitting to lock. Pull down to check for secure 
      connection.
      Instale las mangueras de conexión rápida entre el lado del adaptador del 
      tubo del vertedor y las válvulas. Empuje la conexión para que se bloquee, 
      empújela hacia abajo para verificar que esté bien afianzada.
      Relier le tuyau souple à raccords rapides à l'adaptateur de la tige du bec 
      et au robinet. Pousser sur le raccord pour le verrouiller et tirer dessus pour 
      vérifier qu’il est solidement fixé.
1. 
Remove adaptor 
assembly 
from spout 
shank.
      Quite el conjunto del adaptador del 
vástago del vertedor.
      Enlever l’assemblage de l’adaptateur 
      de la tige du bec.
       
2. 
Position the spout shank in the second hole of 
sink. Secure with rubber seal, metal washer, 
and tighten the spout shank with lock nut.
       
       Posicione el cuello de goma, la arandela de 
metal y la contratuerca de la rosca del cuello.
       
       Placer le bec dans le deuxième orifice de l’évier. 
Fixer à l’aide de la rondelle étanche et de la 
rondelle de métal, puis serrer la tige du bec à 
l’aide de l’écrou de blocage.
4. 
Place the body in the third hole of sink. From underneath the sink, 
replace the washer and lock nut.
      Ponga el cuerpo en el tercer orificio del fregadero.  Por debajo del 
fregadero, reemplace la arandela y la contratuerca.
        
      Mettre le corps dans le troisième orifice de l’évier. Replacer la rondelle 
et l’écrou de blocage à partir du dessous de l’évier.
3. 
Reinstall the adapter to the bottom of the 
spout and secure with locknut.
      Vuelva a instalar el adaptador en la parte 
inferior del vertedor y sujételo con la 
contratuerca.
      Réinstaller l’adaptateur sur l'extrémité de la 
tige du bec avec un écrou de blocage.
Faucet Installation Procedures/Instalación del Grifo/Procédures d’installation du robinet
Shut off main water supply before installation.
Cierre el suministro de agua antes de instalar.
Couper l’alimentation d’eau principale avant l’installation.
Danze recommends that plumbing products be installed by a licensed professional.
Danze aconseja que sea un profesional autorizado quien instale los productos de plomería.
Danze recommande que les articles de plomberie soient installés par un professionnel qualifié.
Maintenance
 
Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft 
cloth.Avoid abrasive cleaners, steel wool and harsh chemicals as these  will dull the finish and void your warranty.
Spout/
Vertedor/
bec
Handle/
Manija/
Manette