Iron-A-Way AS463A Specification Guide
Current as of 06/01/12
www.ironaway.com
SPECIFICATIONS
Product Model Numbers
Ironing Centers: A-46 Swivel
Dimensions (Actual Size)
Overall height: 60 5/8”
Overall width: 15”
Overall depth including door: 7 3/8”
Dimension from wall to outer
edge of door (when recessed): 3 1/2”
Penetration into opening: 3 7/8”
Wall opening height: 59 7/8”
Wall opening width: 14 ¼”
Wall opening depth: 3 7/8”
Overlap distances when using wall
opening dimensions listed above
Top overlap: 3/8”
Bottom overlap: 3/8”
Right side overlap: 3/8”
Left side overlap: 3/8”
Additional Information
•
Unit may be surface mounted (unit extends
approximately 7 3/8” into room) or recessed
(unit extends approximately 3 1/2” into room)
into any wall with standard 16” center studs.
approximately 7 3/8” into room) or recessed
(unit extends approximately 3 1/2” into room)
into any wall with standard 16” center studs.
•
See table to the right to determine desired
ironing board height above the floor. The user
can adjust height of board after installation with
a 4” differential between a maximum and
minimum height.
ironing board height above the floor. The user
can adjust height of board after installation with
a 4” differential between a maximum and
minimum height.
•
Unit can be provided with a left hinged door
upon request. Right hinge is standard.
upon request. Right hinge is standard.
•
Comes standard with birch veneer door.
•
Electrical requirements: 115/120v, 15 amp.
Pigtails are provided in bottom of wire raceway
for hookup to supply line. Make entrance into
knockout provided in top of wire way through
left-hand vent hole.
Pigtails are provided in bottom of wire raceway
for hookup to supply line. Make entrance into
knockout provided in top of wire way through
left-hand vent hole.
•
Recommended to attach 2” x 4” cleats to studs,
level with the bottom of opening (for support
when recessing unit.)
level with the bottom of opening (for support
when recessing unit.)
•
Door opens approximately 180°. Allow at least
16” to the side of the unit for door to swing open
(door hinges on full length piano hinge.)
16” to the side of the unit for door to swing open
(door hinges on full length piano hinge.)
•
Options include: Surface mount trim (necessary
for surface mounting), oak, maple, pine, or
white raised panel door, flat white door, glass
mirrored door, or no door, sleeveboard,
rough-in kit, and iron.
for surface mounting), oak, maple, pine, or
white raised panel door, flat white door, glass
mirrored door, or no door, sleeveboard,
rough-in kit, and iron.
See Page 2 for additional information
Height Adjustments
Cut Opening
Regular (Adjusted)
Above floor Position Position
24”
38”
42”
23”
37”
41”
22”
36”
40”
21”
35”
39”
20”
34”
38”
19”
33”
37”
18”
32”
36”
17”
31”
35”
16”
30”
34”
15”
29”
33”
Board
automatically
engages to low
position each time
the board is
lowered for use.
High position
requires
adjustment and
engages back to
low position every
time the board is
put away.
automatically
engages to low
position each time
the board is
lowered for use.
High position
requires
adjustment and
engages back to
low position every
time the board is
put away.