Dacor DDW24S Installation Instruction

Installation Instructions

4.  Check for leaks under the dishwasher and under 

the sink. If any leaks are found, immediately push 

the 

StOP button and disconnect power. If there 

are leaks under the sink, check the water supply 

and drain connections. Reconnect power and 

restart the cycle. If the leak is elsewhere, and 

a hose extension is installed, check for a loose 

connection. 

5.  If the dishwasher functions normally, complete 

the installation as instructed on the following 

sections.

If the dishwasher fails to operate 

properly:

•  Verify that power is supplied to the dishwasher.
•  Check all plumbing connections.
•  Check for kinks in the water supply line and the 

drain hose.

•  Repeat the Wet Test Checklist.
•  If the appliance still does not work, contact Dacor 

Distinctive Service at (877) 337-3226. Do not 

attempt to repair the appliance yourself. If you 

need service, be sure to have the model and 

serial numbers available when you call. See the 

inside cover for location.

Dacor is not responsible for the cost of correcting 

problems caused by a faulty installation.

Final Leveling

1.  Check to make sure that adjacent drawers and 

cupboards can be opened when the dishwasher 

door is open. Reposition the dishwasher if 

necessary.

2.  Check that there is a 1/8” (3.0 mm) space 

between the top of the dishwasher door and the 

underside of the cabinet. 

3.  If necessary adjust the front leveling legs until the 

dishwasher is the correct height. Both front legs 

must contact the floor solidly.

4.  Check to make sure the unit is level side to 

side and front to back. Also check to make sure 

both front legs are contacting the floor securely. 

Readjust the leveling legs as necessary. 

NOtE: 

The unit may have an inclination of 3/16” (5.0 

mm) maximum without affecting performance.

5.  Once level, hand tighten the front leg retaining 

nuts. Tighten them into place using a crescent 

wrench.  

 1/8” (3.0 mm)