Summit SEH4630 Manual
9
14
In order to hang the product onto hanging screw, there are 2
hanging parts in L shape. Those parts are provided with
screw set for packing facilities. Before mounting the product,
screw the hanging parts with bolts in size M5 x 40 on to M5
nailing nuts.
hanging parts in L shape. Those parts are provided with
screw set for packing facilities. Before mounting the product,
screw the hanging parts with bolts in size M5 x 40 on to M5
nailing nuts.
Fix the connector box to the motor junction plate with 2 pieces
of 3,5 x 9,5 RYSB screws as shown.
of 3,5 x 9,5 RYSB screws as shown.
INSTALL MOUNTING BRACKETS
1. Construct wood wall framing(with
minimum thickness of 8 mm) that is
flush with interior surface of wall
studs.
1. Construct wood wall framing(with
minimum thickness of 8 mm) that is
flush with interior surface of wall
studs.
Make sure:
a) the framing is centered over
installation location.
a) the framing is centered over
installation location.
b) the height of the framing will allow
the mounting brackets to be secured
to the framing.
the mounting brackets to be secured
to the framing.
2. After wall surface is finished,
secure mounting brackets to framing
using the assembly scheme. See the
next page.
secure mounting brackets to framing
using the assembly scheme. See the
next page.
FRAMING BEHIND DRYWALL
wood wall with minimum
thickness of 8 mm
thickness of 8 mm
A
B
Ø8
Ø8
A
B
Ø10
Ø10
B
B
D
Ø10 C
Ø10
CLEANING AND MAINTENANCE
*
*
Disconnect the device prior to maintenance (cut off its power supply by turning off
the switch).
the switch).
*
The aluminum cassette filter holds oils and dust from the air. The metal filter must
be washed in hot soapy water every month, if possible in the dishwasher at
140°F.
be washed in hot soapy water every month, if possible in the dishwasher at
140°F.
*
To disassemble, press on the spring clamps at the edge of the cassette filter.
(Do not reassemble before drying after cleaning.)
(Do not reassemble before drying after cleaning.)
*
Outer surfaces of the hood should be wiped with a cloth dampened with a solution
of liquid detergent. Do not clean the unit with products containing corrosive
substances.
of liquid detergent. Do not clean the unit with products containing corrosive
substances.
*
Avoid wetting switches or other electronic parts when cleaning with water or
other liquids.
other liquids.
*
When cleaning stainless steel surfaces, use products specifically made for this
use.
use.
Note: Aluminum filters may change color after several washings in the dishwasher.
This is normal and does not affect the performance of the filter.
CARBON FILTER REPLACEMENT
Before replacing the round carbon filters, disconnect the power to your device. The
carbon filters are located behind the metal filter, on the left and the right sides of the
blower. First, take out the metal filter. To replace the carbon filters, remove the old
ones from the device and mount the new ones as shown. In kitchens that do not
have a chimney outlet, the carbon filter should be replaced every 3-5 months
depending on usage.
Before replacing the round carbon filters, disconnect the power to your device. The
carbon filters are located behind the metal filter, on the left and the right sides of the
blower. First, take out the metal filter. To replace the carbon filters, remove the old
ones from the device and mount the new ones as shown. In kitchens that do not
have a chimney outlet, the carbon filter should be replaced every 3-5 months
depending on usage.