Fire Magic 33830SW Installation Instruction

1

L-C2-197

REV 9 - 1004081058

Robert H. Peterson Co.  •  14724 East Proctor Avenue  •  City of Industry, CA 91746 

INSTALLER: Leave these instructions with consumer.  
CONSUMER: Retain for future reference.

When connecting this appliance to a power 
supply make sure that it is the same voltage as 
the unit rating. Improper connection may cause 
severe damage to the components or decrease 
the performance of your Fire Magic

®

 electric 

warming drawer. A rating plate specifying voltage, 
hertz, wattage, and amps is attached to the 
unit and also located on page 3. To avoid the 
risk of property damage and/or personal injury, 
installation work and electrical wiring must be 
performed by a qualifi ed professional installer. 
This appliance must be installed in accordance 
with this instruction.

  Removing permanently affi xed rating label 

warnings WILL void the warranty.

  Observe all local codes and ordinances when 

installing this appliance. If no local codes are 
applicable, wire unit in accordance with the 
National Electrical Code, ANSI/NFPA 70, latest 
edition.

• 

When installing this unit directly below another unit, 
only install with Fire Magic

®

 built-in products.

•  This appliance does not contain a fuse or surge 

protector.

•  The power to the unit must be made readily 

accessible to the operator through means of a line 
disconnect switch, circuit breaker, and/or easy to 
reach receptacle.

• 

For safe operation ensure that the unit is grounded 
properly per applicable electrical codes.

•  Not following these instructions exactly will void 

the manufacturer’s warranty.

•  For outdoor installation, the circuit must have 

ground fault interrupt.

To minimize the risk of property damage and/or 
personal injury, do not use a fl exible extension 
power-supply cord in addition to the one supplied 

with this appliance.

Important:  Read these instructions carefully 

before starting installation.

33830-SW shown