Whirlpool LER3622PQ Leaflet

®

LER3622P

Electrical: A four-wire or three-wire, single
phase, 120/240-volt, 60-Hz, AC-only, electrical
supply (or 120/208-volt electrical supply, if
specified on the serial/rating plate) is required on a
separate 30-amp circuit, fused on both sides of the
line. A time-delay fuse or circuit breaker is
recommended.

Exhaust venting: Exhaust your dryer to the
outside. Four-inch diameter vent is required. Rigid
or flexible metal exhaust vent must be used. Do
Not use plastic or metal foil vent. Exhaust outlet
hood must be at least 12 inches from the ground
or any object that may be in the path of the
exhaust.

Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only.  For complete details, see Installation
Instructions packed with product.  Specifications subject to change without notice.

Ref. 8577196

08-24-05

*

*Additional spacing recommended

A

B

A

B

C

36 ft (11 m)
28 ft (8.5 m)

26 ft (7.9 m)
22 ft (6.7 m)

26 ft (7.9 m) 
18 ft (5.5 m)

16 ft (4.9 m)
12 ft (3.7 m)

16 ft (4.9 m)

8 ft (2.8 m)

6 ft (1.8 m)
2 ft (0.6 m)

For closet installation
with a door, minimum
ventilation openings
in the top and bottom
of the door are
required. Louvered
doors with equivalent
ventilation openings
are acceptable.

*Most installations require a

minimum 5

¹⁄₂" (14.0 cm)

clearance behind the dryer for
the exhaust vent with elbows.

Select the route that will provide the straightest and most direct path
outdoors. Plan the installation to use the fewest number of elbows and turns.
Use the fewest 90° turns possible.  

Do not use vent runs longer than specified in vent length chart.

Determine the number of elbows you will need.