Monogram ZDP304NPSS Installation Instruction

REMOVE PACKAGING

•Cut the metal banding. Lift the carton straight up.

•Locate the two runner strips from the top

of the packaging. These strips will be used to
protect the kitchen floor during installation.

•Remove corner posts. Dispose of packaging

materials.

•Remove grill/griddle covers, grill grate and burner

grates.

•Lift out cast-iron griddle flue cover, grease troughs

and pads.

STEP 1

Hinge
Lock

Slot

Installation

•Cut the ties holding the grill grate to the grill frame.

•Lift off burner caps and remove foam pad,

then lift off burner heads and remove foam pad.

CAUTION

Doors and passageways leading to the installation
location require at least 32" opening. If the opening
is less than 32", the oven door(s) and control knobs
must be removed.

REMOVE THE OVEN DOOR(S) ONLY IF NECESSARY to
move the range through the doorways. To prevent
damage to the sides of the range, it will be
necessary to pad the corners beneath the straps
on the hand-truck.

To remove the oven door(s):

• Fully open the door.

• Each hinge has a hinge latch. Close the hinge

latch down against the door frame.

• Firmly grasp the door at the top sides.

• Close the door to the near-vertical position.

• Lift the door up and pull straight out.

• Remove the control knobs by pulling them

straight out.

Griddle Flue Cover

Grease Troughs

Ties

Remove Foam Pads

CAUTION

Stand clear. The ends of the cut metal banding may
snap toward you.

• Open oven door(s) and remove packaging.

Remove shelf holding broiler pan, tape, literature
package, shelf lubricant and probe.