Monogram ZDP304NPSS Installation Instruction

IMPORTANT: Disconnect the range and the
individual shut-off valve from the gas supply piping
system during any pressure testing of that system
at test pressures greater than 1/2 psig. Isolate the
range from the gas supply piping system by closing
the individual manual shut-off valve to the range
during any pressure testing of the gas supply piping
system at test pressures equal to or less than 
1/2 psig.

NOTE: This range is equipped with a gas shut-off
valve located on top of the range, beneath the rear
vent. This shut-off valve is to be used in the event
that service is required in the future. 

Do not use a flame to check for gas leaks.

• Apply pipe thread sealant to the gas inlet located

at the back of the range. Install the 1/2" pipe 
elbow (provided) to the gas inlet.

• Connect 5/8" O.D. flexible metal connector 

to gas inlet. Connect the other end of the flexible
connector to the house gas supply.

• Turn on the gas and check for leaks:

– Use a liquid leak detector at all joints 

and connections in the system.

Gas 
Inlet

• Plug power cord into properly grounded

receptacle.

• Verify that power is connected by opening 

the oven door or press the button on the left side
of the control panel to illuminate the accent
lighting.

The Anti-Tip Bracket must be properly installed 
to prevent tipping of the range. Failure to do so 
can cause serious damage or injury.

• Check to be sure the appliance runners are

beneath the wheels.

• The range is shipped with the wheels in the down

position. Carefully roll the range into position,
being careful not to entangle or pinch the power
cord and flexible gas tubing.

• Remove the runners beneath the range.

Be sure Anti-Tip
Bracket is engaged
with the brace 
on the range.