Monogram ZDP304NPSS Installation Instruction

Page of 68
ZX12B30PSS, ZX12B36PSS, ZX12B48PSS Accessory Installation
OPTIONAL ACCESSORIES—12" HIGH BACKSPLASH
TOOLS AND MATERIALS REQUIRED
• Gloves to protect against sharp edges
• T-15 and #2 Phillips screwdrivers
• Drill with 3/32" and 9/64" bits
• Safety glasses
• Level
• Pencil
This Kit Includes
• Wall support panel
• Cover panel
• Hardware package with 
– 5 Stainless Steel Torx 15 #8 
self-tapping screws
– 5 Phillips #2 pan head wood
#10 screws
Wall Support
Panel
Hardware
Package
INSTALL 12" BACKSPLASH
WARNING:
This backsplash must 
be securely fastened to the wall. Failure to do 
so could result in damage or personal injury.
• Install and level the range or rangetop and the
range hood according to the installation
instructions.
• Remove the backsplash packaging and 
protective film.
• Use a level to pencil a horizontal line on the wall,
1/8" above the range or rangetop. The 1/8" gap
allows the cover panel to overlap the wall support
panel.
• Locate wall studs on each side. Where studs are not
available, plan to use wall anchors (not provided).
• Align the wall support panel on the marked
horizontal line and centered left to right.
• The wall support panel must be secured to the wall
at all 4 corners. Use wood screws (provided) or wall
anchors (not provided) to secure the support panel
to the wall.
• Place the cover panel over the wall support 
panel and secure with Torx screws (provided). 
Install 2 screws on each side.
Install 4 Wood
Screws
1/8
Install T-15
Screws
Wall 
Support 
Panel
761Dia65
Wall Support 
Panel
Cover Panel
18
Cover Panel
WARNING:
To prevent ignition of combustible materials, 
the entire back wall above the range must 
be protected by a backsplash constructed 
of non-combustible material.
This stainless steel backsplash accessory 
must be installed in combination with a custom,
non-combustible backsplash built beyond 
the 12" height of the backsplash.
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
IMPORTANT: Save these instructions for local
inspector’s use. 
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these
instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions
with your Owner’s Manual for future reference.
This kit provides for the installation of a 12" high
backsplash for 30", 36" or 48" Monogram
Professional Ranges and Rangetops.
Center 
Arrow