Iron-A-Way E46 Specification Sheet
Specifications
February 2015
Product Model Numbers
Ironing Centers: E-46 and NE-46
Dimensions (Actual Size)
Overall height: 60 5/8”
Overall width: 15”
Overall depth including door: 7 3/4”
Dimension from wall to outer
Edge of door (when recessed): 3 7/8”
Penetration into opening: 3 7/8”
Rough opening height: 59 7/8”
Rough opening width: 14 3/8”
Wall opening depth: 3 7/8”
Opening dimensions listed above
Overlap distances when using wall
Top overlap: 3/8”
Right side overlap: 3/8”
Bottom overlap: 3/8”
Left side overlap: 3/8”
Additional Information
•
Unit may be surface mounted (unit extends
approximately 7 3/4” into room) or recessed
(unit extends approximately 3 7/8” into room)
into any wall with standard 16” center studs.
•
See table bottom right to determine desired
ironing board height above the floor.
•
Unit can be provided with a left hinged door
upon request. Right hinge is standard.
•
Comes standard with wood veneer door.
•
Electrical requirements for E-46: 115/120v, 15
amp. Pigtails are provided in bottom of wire
raceway for hookup to supply line. Make
entrance into knockout provided in top of
wire way through left-hand vent hole. (Refer
to Top View Diagram.)
•
Electrical requirements for NE-46: Does not
require electricity, non-electric.
•
Recommended to attach 2” x 4” cleats to
studs, level with the bottom of opening (for
support when recessing unit.)
•
Door opens approximately 180°. Allow at
least 16” to the side of the unit for door to
swing open (door hinges on full length piano
hinge.)
•
Options include: Surface mount trim
(necessary for surface mounting), oak, maple,
pine, or white raised panel door, flat white
door, glass mirrored door, or no door, sleeve
board, swivel, rough-in kit, and iron.
See Page 2 for additional information
Ironing Board Height
Cut Opening Board
Above floor Height
27” 38”
26” 37”
25” 36”
24” 35”
23” 34”
22” 33”
21” 32”
20” 31”
19” 30”