Dacor DR30DLP Installation Instruction
8
Installation Instructions
Removing the Oven Door
To make the range easier to move, remove the door to reduce
weight.
WARNING
Do not attempt to disengage the hinge catches with the
•
door removed from the oven. The hinge springs could
release causing personal injury.
Do not lift or carry the oven door by the handle.
Do not lift or carry the oven door by the handle.
•
Open the door to its fully opened position.
1.
Using a screwdriver, rotate the catch over the retaining arm
2.
on each hinge.
Lift the oven door to about a 15° angle from the vertical
3.
position.
Hold the door with both hands just below the handle and pull
Hold the door with both hands just below the handle and pull
4.
it away from the oven while continuing to lift.
Electrical Connection
WARNING
Wire the range only in compliance with local ordinances.
•
Do not turn on power to the range until instructed to do
•
so in the Verifying Proper Operation section of these
instructions.
Improper connection of the electrical wiring can cause an
Improper connection of the electrical wiring can cause an
•
electric shock hazard and damage the appliance. Dacor
is not responsible for damages resulting from improper
installation.
The ground terminal (or lead) on the appliance must be
The ground terminal (or lead) on the appliance must be
•
connected to a grounded, metallic, permanent wiring system
or grounding conductor.
Do not use an extension cord with this appliance. Such use
Do not use an extension cord with this appliance. Such use
•
may result in fire, electric shock or other personal injury.
Do not install a fuse in the neutral or ground circuit. A fuse
Do not install a fuse in the neutral or ground circuit. A fuse
•
in the neutral or ground circuit may result in an electric
shock hazard.
IMPORTANT:
Some models come pre-wired at the factory with a 4-wire
•
appliance cord for connection to a 14-50R electrical
receptacle as specified on page 4. If the range being installed
is pre-wired, skip to Gas Connection on page 13. This
section does not apply to pre-wired units.
Do not disconnect any of the wires inside the range electrical
Do not disconnect any of the wires inside the range electrical
•
box unless instructed to do so.
Make sure that the conduit or appliance cord is long enough
Make sure that the conduit or appliance cord is long enough
•
to allow the range to be pulled out for service without
disconnecting it from power.
Catch
Retaining arm
Put slack in
electrical wiring
and gas line
Door Gripping Points
Back of range
Electrical access cover