Broan 15WT User Manual

BACK OF 

COMPACTOR

WOOD

BLOCK

ADjUSTING 

SCREWS

SLOTS

ROLLERS

FRONT OF 

COMPACTOR

WOOD

BLOCK

LEVELING

LEGS

Your compactor has four adjustable levelers; (2) rollers in 
the rear and (2) legs in the front. They allow you to adjust 
for uneven floors and also trim the unit up to fit an under-
counter installation.

To level the back of the compactor:
Tip the 

back of compactor up and onto a wood block. Loosen 

the 

adjusting screws only far enough to move the rollers to 

a higher or lower 

slot. Retighten the adjusting screws and 

remove the wood block.

To level the front of the compactor:
Tip the 

front of compactor up and onto a wood block. Turn 

the 

leveling legs in or out to the desired position. Remove 

the wood block.

As shipped, the compactor door is hinged on the right 
(when looking at the unit).

To change door to be hinged on the left:
1. With the door closed, use a 3/16” allen wrench to 

remove the 

.

2. 

Carefully remove 

door by opening and sliding the 

bottom of the door away from the cabinet.

3. Use a 3/16” allen wrench to remove the 

bracket from the cabinet (2 screws).

DOOR

LOWER 

HINGE PIN

LOWER HINGE 

BRACKET

SCREWS

4. 

Turn the bracket over and install the 

bracket on the opposite side of the 
cabinet using the same screws.

5. Use a screwdriver to remove the 

upper hinge pin from the 

trim piece and reinstall the pin on the opposite side.

UPPER 

HINGE 

PIN

TRIM PIECE