Monogram ZV36TSFSS Installation Instruction

• Install ductwork, making connections in direction of

airflow as illustrated.

• Secure joints in ductwork with sheetmetal screws.
• Wrap all duct joints with duct tape for an airtight seal.
• Use duct tape to seal the flange connection. Reach

inside the hood and push the damper up to be sure it
moves freely.

For easier handling, remove cardboard insert

after film is peeled off.

Remove protective film from duct covers. If more than
one duct cover is used, secure each piece together with
screws provided.
• Place the duct cover(s) on top of the hood.
• From inside the hood, secure the duct cover to the

top with the small Phillips head screws supplied with
the covers.

If house wiring is not

2-wire with a ground wire, a ground must be provided
by the installer. When house wiring is aluminum, be
sure to use U.L. approved anti-oxidant compound
and aluminum-to-copper connectors.

 Si le câblage

de la maison n’est pas du type à deux fils avec un fil de
terre, l’installateur doit fournir un circuit de terre.
Quand les fils de la maison sont en aluminium, il
prendre soin d’utiliser de la pâte antioxidation
approuvée par UL et des connecteurs pour
l’aluminium-cuivre.

• Use wire nuts to connect incoming ground to green,

white to white and black to black.

• Push wires into junction box and replace cover. Be

sure wires are not pinched.

White

Ground

Black

Remove

Junction Box

Cover

Insert Power
Conduit Thru

Strain Relief

and Tighten

Use UL Listed

Wire Nuts

Screw

Duct Tape
Over Seam 
and Screw

Air Flow

Duct Tape

Over Transition