Monogram ZV36TSFSS Installation Instruction

• Lift out the wooden crossmember, as well as the top

protective carton.

• Lift out the four “L” shaped polystyrene protection

profiles.

• Remove the protection moldings around the smaller

carton box.

• Remove the small box housing the motor.
• Lift the hood out of the box.

 Lift the hood by grasping

the outside edges of the inlet opening of the hood.
Do not lift the hood by the exhaust opening divider—
damage will occur!

• Remove the shipping screws holding the wood

mounting piece to the back side of the hood.
Set aside the wood mounting piece and screws
for later installation. Do not discard

.

• Remove the “V” shaped carton insert.
• Remove the parts package from the “V” shaped

cardboard insert.

• Remove the junction box cover and knockout.
• Install the strain relief onto the back or top of the hood.
• Remove all tape and packing material from the hood,

duct transition and motor.

Pencil and tape measure

Pliers

Electric or battery operated drill
and 1/8", 3/8" bits

120V 60Hz. 15 or 20 Amp,
2-wire with ground. Properly
grounded branch circuit.

Key Hole Saw

Hammer

Wire cutter/stripper

Step ladder

Metal Snips

Saber saw
or Sawsall

Wire nuts

Phillips and flat

blade

screwdrdivers

Strain relief for
junction cover.

Spirit level

Flashlight

Safety glasses

10" round metal
duct, length to
suit installation.

Duct tape

Wood

Mounting

Support

Motor

Hood

Parts

Package

Shipping Carton