Monogram ZBD1850NII Installation Instruction
Installation Instructions
STEP 12 CONNECT WATER SUPPLY
Connect water supply line to 90° elbow.
• Slide compression nut,
then ferrule over end of
water line.
water line.
• Insert water line into 90°
elbow.
• Slide ferrule against
elbow and secure with
compression nut.
compression nut.
Figure EE
Figure FF
STEP 13 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
• Cut drain hose connector on the marked line, if required, to fi t
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
• Cut drain hose connector on the marked line, if required, to fi t
the inlet port.
• If a longer drain hose is required, add up to 42" of length for
a total of 10' to the factory installed hose. Use 5/8" or 7/8"
inside diameter hose and a coupler to
connect the two
hose ends.
Secure the
connection with
hose clamps.
inside diameter hose and a coupler to
connect the two
hose ends.
Secure the
connection with
hose clamps.
Figure GG
• Secure the drain hose to the air gap, waste tee or disposer
with clamps.
Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR
PROPER DRAIN OPERATION.
PROPER DRAIN OPERATION.
Waste Tee Installation
Figure HH
�������
�������
Disposer Installation
Waste Tee Installation
Figure II
Disposer Installation
Method 2 – Drain Hose Routing
Route the drain hose of the dishwasher to a minimum height of 32" from
the fl oor with the supplied hanger as shown.
the fl oor with the supplied hanger as shown.
IMPORTANT
– When connecting
drain line to disposer, check to be sure
that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
Tip: Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.
disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.
������
������
����
�������
����������
�������
����������
����������
18"
Min.
32"
Min.
05A-1183GG
Fasten drain hose at least at
32" height with hanger supplied
IMPORTANT
– Either one of the above methods
must be used or dishwasher will not operate properly.
Method 1 – Air gap with waste tee or disposer
Insert the drain hose to air gap as shown.
Insert the drain hose to air gap as shown.
32"
Min.
18"
Min.
05A-1183FF
Fasten drain hose at least at
32" height with hanger supplied
IMPORTANT
– Check to be sure that door spring does
not rub or contact the fill hose or water supply line. Test by
opening and closing the door. Re-route the lines if a rubbing
noise or interference occurs.
opening and closing the door. Re-route the lines if a rubbing
noise or interference occurs.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer using
either previously determined method.
9
Ferrule
90° Elbow
Compression Nut
Hot Water
Supply Line
10
Cutting Lines
1"
3/4"
5/8"
IMPORTANT: Do not cut corrugated
portion of hose
2