Monogram ZBD1850NII Installation Instruction

White

Ground

Black

 Check That White, Black and

Green Dishwasher Wires Are Threaded

Thru Hole in Back

Remove

Junction Box

Cover

Insert Power

Cord Wires Thru

Strain Relief

and Tighten

Use UL Listed

Wire Nuts

Verify that power is turned off at the source.
• Remove junction box cover “A”.
• Locate the three dishwasher wires, (white, black and green) 

with stripped ends. Insert dishwasher wires through the small 
hole in the junction box “B”.

• Secure house wiring to the bottom of the junction box with a 

strain relief “C”.

• Use wire nuts to connect incoming ground to green, white to 

white and black to black “D”.

• Replace junction box cover “E”. Check to be sure that wires 

are not pinched under the cover.

■

  Check to be sure power is OFF.

  Check to be sure power is OFF.

■

  Open door and remove all foam and paper packaging.

  Open door and remove all foam and paper packaging.

■

  Locate the Owner’s Manual in the literature package.

  Locate the Owner’s Manual in the literature package.

■

  Read the Owner’s Manual for operating instructions.

  Read the Owner’s Manual for operating instructions.

■

  Check door opening and closing. If door does not open and 

  Check door opening and closing. If door does not open and 

close freely or tends to fall, check spring adjustments. See 
Step 1.

■

  Check to be sure that wiring is secure under the dishwasher, 

  Check to be sure that wiring is secure under the dishwasher, 

not pinched or in contact with door springs or other 
components. See Step 9.

■

  Check door alignment with tub. If door hits tub, level 

  Check door alignment with tub. If door hits tub, level 

dishwasher. See Step 10.

■

  Pull lower rack out, about half way. Check to be sure it does 

  Pull lower rack out, about half way. Check to be sure it does 

not roll back or forward on the door. If the rack moves, 
adjust leveling legs. See Step 10.

■

  Check door alignment with cabinet. If door hits cabinet, 

  Check door alignment with cabinet. If door hits cabinet, 

reposition or relevel dishwasher. See Step 10.

■

  Verify water supply and drain lines are not kinked or in 

  Verify water supply and drain lines are not kinked or in 

contact with other components. Contact with motor or 
dishwasher frame could cause noise. See Step 8.

■

  Turn on the sink hot water faucet and verify water 

  Turn on the sink hot water faucet and verify water 

temperature. Incoming water temperature must 
be between 120°F and 150°F. A minimum of 120°F 
temperature is required for best wash performance. See 
“Prepare Hot Water Line,” page 5.

■

  Add 2 quarts of water to the bottom of the dishwasher to 

  Add 2 quarts of water to the bottom of the dishwasher to 

lubricate the pump seal.

■

  Turn on water supply. Check for leaks. Tighten connections 

  Turn on water supply. Check for leaks. Tighten connections 

if needed.

■

  Remove protective film if present from the control panel 

  Remove protective film if present from the control panel 

and door.

■

  Avoid service call charges by ensuring there is an air gap 

  Avoid service call charges by ensuring there is an air gap 

or drain hose routed through the required 32" minimum 
height.

#282 French

If house wiring is not 2-wire with ground, a 
ground must be provided by the installer. 
When house wiring is aluminum, be sure to 
use UL Listed anti-oxidant compound and 
aluminum-to-copper connectors