Monogram ZBD1850NII Installation Instruction

■

  Turn on power supply (or plug power cord into outlet, 

  Turn on power supply (or plug power cord into outlet, 

if equipped).

■

  Start the unit to check for leaks.

  Start the unit to check for leaks.

– Press ON/OFF button to turn unit on
–  Press CYCLE SELECT button until light below RINSE cycle 

illuminates

■

  Close door.

  Close door.

■

  Check to be sure that water enters the dishwasher. If water 

  Check to be sure that water enters the dishwasher. If water 

does not enter the dishwasher, check to be sure that water 
and power are turned on.

■

  Check for leaks under the dishwasher. If a leak is found, turn 

  Check for leaks under the dishwasher. If a leak is found, turn 

off power supply, then tighten connections. Restore power 
after leak is corrected.

■

  Check for leaks around the door. A leak around the door 

  Check for leaks around the door. A leak around the door 

could be caused by door rubbing or hitting against 
adjacent cabinet. Reposition the dishwasher if necessary. 
See Step 9.

■

  The dishwasher will drain and turn off about 5 to 7 minutes 

  The dishwasher will drain and turn off about 5 to 7 minutes 

after the first fill. Check drain lines. If leaks are found, 
turn power off at the breaker and correct plumbing as  
necessary. Restore power after corrections are made. See 
Step 12.

■

  Open dishwasher door and make sure most of the water 

  Open dishwasher door and make sure most of the water 

has drained. If not, check that disposer plug has been 
removed and/or air gap is not plugged. See Step 13. Also 
check drain line for kinking.

■

  Run the dishwasher through another fill and drain cycle. 

  Run the dishwasher through another fill and drain cycle. 

Check for leaks and correct if required.

■

  At the end of drain, open door and press ON/OFF button to 

  At the end of drain, open door and press ON/OFF button to 

turn unit off.

• Place 2-piece toekick against the legs of the dishwasher.
• Place the inner toekick piece (with slots) against the toekick 

bracket. The slots should align with toekick bracket screw 
holes. Allow the toekick to touch the fl oor.

• Place larger toekick over the inner piece and install 4 toekick 

screws.

• Use additional 2 screws for installations over 33-1/2" high.
• Use both toekick pieces for all installation heights.

• Be sure to leave complete literature package and Installation 

Instructions with the consumer.

GE Consumer & Industrial
General Electric Company
Louisville, Kentucky 40225

monogram.com

© 2005 General Electric Company

        

     Pub. No. 31-30243

Dwg. No. 206C1559P181

ND 08C-2515 (4/08)

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

2-Piece Toekick

Adjust Up

or Down

Use Top 4

Screw Holes