Monogram ZBD1850NII Installation Instruction

Page of 14
90
°
Elbow
Fill
Hose
Thread
Seal Tape
Water
Valve
Bracket
White
Ground
Black
 Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Hole in Back
Remove
Junction Box
Cover
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
Use UL Listed
Wire Nuts
A
C
B
D
Installation Instructions
STEP 2 ADJUST LEVELING LEGS
• Move the dishwasher close to the installation location and lay 
it on its back.
Figure L
• Measure installation height and dishwasher height. Extend 
leveling legs out from the dishwasher base, 1/2" less than 
installation height.
STEP 3  REMOVE TOEKICK
• Remove the 4 toekick screws. Lift off the 2 piece toekick.
STEP 4 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
Use Power Cord Kit WX09X70910, available for purchase 
from an authorized GE Appliance Dealer. The power cord and 
connections must comply with the National Electrical Code, 
Section 422 and/or local codes and ordinances.
• Maximum power cord length is 6'.
• Connect incoming power cord white (or ribbed) to dishwasher 
white, black (or smooth) to black and ground to dishwasher 
green wire. Use UL listed wire nuts of appropriate size.
• Replace junction box cover. Be sure wires are not pinched 
under the cover.
Figure N
Figure O
STEP 5  INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
• Do not over tighten 90° elbow, water valve bracket could 
bend or water valve fi tting could break.
• Position the end of the elbow to face the rear of the 
dishwasher.
Adjust to
Installation
Height
Remove
4  Toekick
Screws
Figure M
8