Monogram ZBD1850NII Installation Instruction

Page of 14
Installation Instructions
STEP 6  POSITION WATER LINE AND 
HOUSE WIRING
• Position water supply line and house wiring on the fl oor of 
the opening to avoid interference with base of dishwasher 
and components under dishwasher.
Figure P
Figure Q
Figure R
STEP 7  INSTALL DRAIN HOSE THROUGH 
CABINET
• Stand the dishwasher upright and position in front of the 
opening. Insert drain hose into cabinet wall hole. If a power 
cord is used, guide the end through a separate hole.
TIP: Position water line and house wiring on the floor
to avoid interference with base of dishwasher.
STEP 8  SLIDE DISHWASHER PARTIALLY 
INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a time.
• As you proceed, pull the drain hose through the opening 
under the sink. Stop pushing when the dishwasher is a few 
inches forward of adjacent cabinetry.
• Make sure drain hose is not kinked under the dishwasher and 
there is no interference with the water line and wiring or any 
other component.
Water 
Line 
House 
Wiring 
4" 
6" 
Power Cord 
(If Used) 
Water 
Line 
House 
Wiring 
Drain 
Hose 
Insulation 
Blanket 
Maximum
Drain Hose
Length 10”
9
Do Not Push Against
Front Door Panel With 
Knee. Damage to The 
Door Panel Will Occur.
Reposition Dishwasher 
by Grasping Both Sides 
With Hands.