Kingston Technology 6GB, 1600MHz, DDR3, Non-ECC, CL9 (9-9-9-27), DIMM, (Kit of 3), Tall HS XMP KHX12800D3T1K3/6GX Data Sheet

Document No. 4805230-001.A00

06/26/09

Page 1

Kingston's KHX12800D3T1K3/6GX is a triple-channel kit of three 256M x 64-bit 2GB (2048MB) DDR3-1600MHz CL9
SDRAM (Synchronous DRAM) memory modules, with each module based on sixteen 128M x 8-bit DDR3 FBGA
components. Total kit capacity is 6GB. Each module kit supports Intel

 XMP (Extreme Memory Profile)

.

 Each module kit

has been tested to run at DDR3-1600MHz at a latency timing of 9-9-9-27 at 1.65V. The SPDs are programmed to JEDEC
standard latency DDR3-1333MHz timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact fingers and requires
+1.5V. The JEDEC standard electrical and mechanical specifications are as follows:

JEDEC standard 1.5V ± 0.075V Power Supply

VDDQ = 1.5V ± 0.075V

667MHz fCK for 1333Mb/sec/pin

8 independent internal bank

Programmable CAS Latency: 6,7,8,9

Posted CAS

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

Programmable CAS Write Latency(CWL) = 7(DDR3-1333)

8-bit pre-fetch

Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4

which does not allow seamless read or write [either on the fly using A12 or MRS]

Bi-directional Differential Data Strobe

Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)

On Die Termination using ODT pin

Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C

Asynchronous Reset

PCB : Height 2.401” (61.00mm) w/ heatsink, double  sided  component

CL(IDD)

9 cycles

Row Cycle Time (tRCmin)

49.5ns (min.)

Refresh to Active/Refresh Command Time (tRFCmin)

110ns

Row Active Time (tRASmin)

36ns (min.)

Power

2.160 W (operating per module)

UL Rating

94 V - 0

Operating Temperature

0

o

 C to 85

o

 C

Storage Temperature

-55

o

 C to +100

o

 C

Ke

ye

d

Ke

ye

d