Summit GC22SS Owner's Manual
9
ADJUSTMENTS
Always disconnect the appliance from the electrical power source before making any
adjustments. All seals must be replaced by the technician when any adjustments are completed.
adjustments. All seals must be replaced by the technician when any adjustments are completed.
Taps
"Reduced rate" adjustment:
1.Switch on the burner and turn the relative knob to the “Reduced rate” position (small flame fig. 8 page
10).
2. Remove knob “M” (fig. 6 and 6/A) of the tap, which is simply pressed on to its rod.
3. The by-pass for minimal rate regulation can be: beside the tap (fig. 6) or inside the shaft. In any case,
to access to regulation, it can be done trought the insertion of a small screwdriver ‘’D’’ beside the tap (fig.
6) or in the hole ‘’C’’ inside the shaft of the tap (fig 6/A).
1.Switch on the burner and turn the relative knob to the “Reduced rate” position (small flame fig. 8 page
10).
2. Remove knob “M” (fig. 6 and 6/A) of the tap, which is simply pressed on to its rod.
3. The by-pass for minimal rate regulation can be: beside the tap (fig. 6) or inside the shaft. In any case,
to access to regulation, it can be done trought the insertion of a small screwdriver ‘’D’’ beside the tap (fig.
6) or in the hole ‘’C’’ inside the shaft of the tap (fig 6/A).
Turn the throttle screw to the right or left until the burner flame has been adequately regulated to the
“Reduced rate” position.
“Reduced rate” position.
The flame should not be too low: the lowest small flame should be continuous and steady. Re-assemble
the several components.
the several components.
It is understood that only burners operating with Natural Gas or City Gas should be subjected to
the above-mentioned adjustments. The screw must be fully locked when the burners operate with
Propane (turn clockwise).
The operations described above can be carried out easily, whatever the position of the cooktop or
however it is fastened to the work surface.
THE BURNERS DO NOT REQUIRE ANY REGULATION OF INCOMING AIR.
Propane (turn clockwise).
The operations described above can be carried out easily, whatever the position of the cooktop or
however it is fastened to the work surface.
THE BURNERS DO NOT REQUIRE ANY REGULATION OF INCOMING AIR.
FIG. 6
FIG. 6/A