Asko D5656XXLHS1 Installation Instruction
6
7
WARNING!
Plumbing connections must comply with applicable
sanitary, safety and plumbing codes in your area.
sanitary, safety and plumbing codes in your area.
The machine can be connected to either a hot (max. 160
°F, 70 °C) or cold water supply. We recommend a cold
water supply. The water pressure should be 4.2-140 psi.
Connect to cold water...
Connect to cold water...
If you use oil or electricity to heat your home.
Connect to hot water (max 160 °F, 70 °C)...
Connect to hot water (max 160 °F, 70 °C)...
If you use district heating, solar power, or geothermal
power to heat your home. Choosing a hot water
connection cuts program times and reduces the
dishwasher’s electricity consumption.
The dishwasher comes with a 6-foot PEX water supply
The dishwasher comes with a 6-foot PEX water supply
line that has a 3/8˝ NPT female connection.
After determining where the water supply line will enter
After determining where the water supply line will enter
under the sink, drill a 1-1/2˝ (38 mm) access hole and
run the line to the approximate inlet valve location shown
in the figure below. The water line inlet valve is on the
right rear of the machine.
For service convenience, a shut-off valve (not supplied)
For service convenience, a shut-off valve (not supplied)
should be installed in the supply line in an easily
accessible location, such as, beneath the sink.
It is important that the water supply line and the shut off
It is important that the water supply line and the shut off
valve have a sufficient flow volume. At least 3 gallons
(12 liters) per minute must be able to pass through the
line. The water pressure should be 4.2-140 psi.
WARNING!
In order to prevent heat damage to the inlet valve, all
solder connections must be made before the water
line is connected to the dishwasher.
solder connections must be made before the water
line is connected to the dishwasher.
NOTE:
Be sure to run the PEX tubing through the hole to the
sink compartment before moving the dishwasher into
position.
1. Water supply
2. Water supply valve to dishwasher (not supplied)
2. Water supply valve to dishwasher (not supplied)
WATER SUPPLY
If the dishwasher is installed in a corner, there must be
a minimum clearance of 2˝ (50 mm) from the side wall
so the door can open.
2˝ clearance
CORNER INSTALLATION
EASYINSTALL CONNECTIONS
PEX tubing with 3/8˝ compression fitting
PEX tubing has a 95-year spec life.
Fits American dishwasher water
supply valves. Be sure to install the
O-Ring which is attached to the PEX
tubing in a plastic bag.
Drain hose boot
Ready to be cut to desired
drain connection. Only
one clamp required.
Electrical cord
120 volts, 15 amp cord is supplied with
the dishwasher.
WARNING!
Do not use an extension cord for this appliance.
CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM
CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM
492169 Install DW16 USA EN Rev 01.indd 6
2015-01-13 11:12:37