Electrolux EW30GS65GS Installation Instruction

H1

H2

H3

H4

The counter-top around the cut-out should be flat and leveled (see 
hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2) cabinet 
sides (H1-4), front and back (see illustration 1) from the floor to the top 
of the counter.

Illustration 1

Shave
Raised
Edge
to Clear
Space for a 
31½" (81 cm) 
Wide

 

Cooktop.

1 ½" Max.

(3.8 cm Max.)

Remove the protective channels on each side of the cooktop (if provided).

Slide the unit into the cabinet. Make sure the center of the unit is aligned 
with the center of the cabinet cut-out. 

Illustration 2

To successfully 

install the 

range, the initial 

level height 

from floor to 

underside of 

cooktop frame 

should be at 

least 1/16" 

taller than 

cabinet sides 

as measured in 

step 2.

Level the range using the 

two (2) front leveling legs 

and the two (2) adjustable 

leveling wheel, so that the 

height from the floor to 

the underside of the metal 

flange is greater than the 

tallest cabinet measurement 

by at least 1/16" (see 

illustration 2).

After the installation, MAKE SURE that the unit is 
supported by the two front leveling legs and the 
two adjustable leveling wheels and NOT by the 
cooktop.

Metal 

Flange

The metal flange under each side of the cooktop MUST be placed over 
the cabinet countertop for proper unit support.  The cooktop should 
NOT rest directly on the countertop (see illustration 2) or else it could 
cause damage to the cooktop voiding the warranty. Level the unit if 
needed.

Remove and discard the two rear leveling legs, they are only in place to 
solidify the unit for the transport.