Kenwood DDX371 Owner's Manual

54

CONNECTION/INSTALLATION

CONNECTION/INSTALLATION

 Installation procedure

  To prevent a short circuit, remove the key 

from the ignition and disconnect the 

·

 

battery.

  Make the proper input and output wire 

connections for each unit.

  Connect the speaker wires of the wiring 

harness.

  Connect the wiring harness wires in the 

following order: ground, battery, ignition.

  Connect the wiring harness connector to 

the unit.

  Install the unit in your car.

•  Make sure that the unit is installed securely 

in place. If the unit is unstable, it may 
malfunction (eg, the sound may skip).

 Reconnect 

the 

·

 battery.

  Press the reset button.

 Configure 

<Initial Settings>. (page 4)

 Installing the unit

 

•  Bend the tabs of the mounting sleeve with a 

screwdriver or similar utensil and attach it in place.

  When installing the unit using the 

Car Bracket

5 or 6

5 or 6

•  Select the appropriate type of screw for the 

mounting bracket: flat head (

5) or round head 

(

6).

 Installing the trim plate

  Attach the trim plate (

2

).

2

DDX_Entry_K.indb   54

2013/11/01   16:10