KitchenAid KFED500ESS-SS Dimensional Illustrations

Page of 1
30" (76 cm) Freestanding Electric Range
PRODUCT MODEL NUMBERS
PRODUCT DIMENSIONS
KFED500E
•  This range is manufactured with the neural terminal connected 
to the cabinet. Use a 3-wire, UL listed, 40- or 50-amp power supply 
cord (pigtail) (see the following Range Rating chart). If local codes 
do not permit ground throught the neutral, use a 4-wire power 
supply cord rated at 250 volts, 40- or 50-amps and investigated 
for use with ranges.
Range Rating*
Specified Rating of 
Power Supply Cord Kit 
and Circuit Protection
120/240 Volts
120/208 Volts
Amps
8.8 – 16.5 KW
7.8 – 12.5 KW
40 or 50**
16.6 – 22.5 KW
12.6 – 18.5 KW 50
 
*  The NEC calculated load is less than the total connected load listed 
on the model/serial/rating plate.
  **  If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. 
For 50-amp rated cord kits, use kits that specify use with a nominal 
13/8" (39.9 mm) diameter connection opening.
•  A circuit breaker is recommended.
•  The range can be connected directly to the circuit breaker box 
(or fuse disconnect) through flexible or nonmetallic sheathed, 
copper or aluminum cable. See the “Electrical Connection – 
U.S.A. Only” section.
A.   35
3
/
4
" ± 
1
/
8
" (90.8 ± 0.3 cm) cooktop height (minimum) 
with leveling legs screwed all the way in*
B.  Model/serial/rating plates (located behind the control panel)**
C.   47
3
/
8
" ± 
1
/
8
" (120.3 ± 0.3 cm) overall height (minimum) 
with leveling legs screwed all the way in*
D.   28
1
/
2
" ± 
1
/
4
" (72.4 ± 0.6 cm) depth with handle
E.   26
1
/
8
" ± 
1
/
8
" (66.4 ± 0.3 cm)***
F.   29
15
/
16
" ± 
1
/
16
" (76.0 ± 0.2 cm) width
  *  Range can be raised approximately 1" (2.5 cm) by adjusting 
the leveling legs.
 **  Model/serial/rating plates may be roated up from behind the control 
panel for viewing from the front of the range.
*** Excludes handle. Dimension given is from wall to front of oven door 
and will vary based on electronic outlet receptacle installation.
Because Whirlpool Corporation includes a continues commitment to improve our products, 
we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, 
see Installation Instructions packed with product. Specifications subject 
to change without notice.
B**
A*
F
E***
D
C*
A.  18" (45.7 cm) upper cabinet 
to countertop
B.  13" (33.0 cm) upper cabinet depth
C.  30" (76.2 cm) min. opening width
D.  For minimum clearance to the top 
of the cooktop, see NOTE.
E.  U.S.A.: 30" (76.2 cm) min. 
opening width 
Canada: 31" (78.7 cm) min. 
opening width
Ref. W10694065A
02/10/15
Electrical Connection:
CABINET OPENING DIMENSIONS
Cabinet opening dimensions shown are for:
25" (63.5 cm) countertop depth,
24" (61 cm) base cabinet depth,
36" (91.4 cm) countertop height
A
B
C
D
E
F
G
H
I
J
K
F.  Cabinet door or hinge should 
not extend into cutout*
G.  1
1
/
2
" (3.8 cm) min. 
from right side of cabinet
H.  2" (5.1 cm) min. from floor
I.  7" (17.8 cm) min. from floor
J.  8" (20.3 cm) width
K.  3
1
/
2
" (8.9 cm) min. from floor
Proper positioning of outlet shown above.
*  Nothing located in shaded areas can extend more than 1
1
/
2
(3.8 cm) from wall or range will not slide all the way back.
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet 
is covered by not less than 
1
/
4
" (0.64 cm) flame retardant millboard 
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) 
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking 
platform and the bottom of an uncovered wood or metal cabinet.