Sony ICFC707 Owner's Manual

Page of 2
For customers who purchased this product in 
the USA
Please register this product on line at 
http://www.sony.com/productregistration.
Proper registration will enable us to send 
you periodic mailings about new products, 
services, and other important announcements. 
Registering your product will also allow us 
to contact you in the unlikely event that the 
product needs adjustment or modification. 
Thank you.
WARNING
To reduce the risk of fire or electric shock, 
do not expose this apparatus to rain or 
moisture.
To reduce the risk of fire, do not cover the 
ventilation of the apparatus with newspapers, 
tablecloths, curtains, etc. And do not place 
lighted candles on the apparatus.
To reduce the risk of fire or electric shock, do 
not expose this apparatus to dripping or 
splashing, and do not place objects filled with 
liquids, such as vases, on the apparatus.
Do not install the appliance in a confined space, 
such as a bookcase or built-in cabinet.
Do not expose the batteries (battery pack or 
batteries installed) to excessive heat such as 
sunshine, fire or the like for a long time.
As the main plug is used to disconnect the unit 
from the mains, connect the unit to an easily 
accessible AC outlet. Should you notice an 
abnormality in the unit, disconnect the main 
plug from the AC outlet immediately.
The unit is not disconnected from the AC 
power source (mains) as long as it is connected 
to the wall outlet, even if the unit itself has been 
turned off.
You are cautioned that any changes or  
modifications not expressly approved in this 
manual could void your authority to operate 
this equipment.
The nameplate and important information 
concerning safety are located on the bottom 
exterior.
CAUTION
Danger of explosion if battery is incorrectly 
replaced. Replace only with the same type.
NOTE
This equipment has been tested and found to 
comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable 
protection against harmful interference in a 
residential installation. This equipment 
generates, uses and can radiate radio frequency 
energy and, if not installed and used in 
accordance with the instructions, may cause 
harmful interference to radio communications. 
However, there is no guarantee that interference 
will not occur in a particular installation. If this 
equipment does cause harmful interference to 
radio or television reception, which can be 
determined by turning the equipment off and 
on, the user is encouraged to try to correct the 
interference by one or more of the following 
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment 
and receiver.
— Connect the equipment into an outlet on a 
circuit different from that to which the receiver 
is connected.
— Consult the dealer or an experienced radio/TV 
technician for help.
WARNING
 Replace the battery for the clock backup with 
a Sony CR2032 lithium battery. Use of 
another battery may present a risk of fire or 
explosion. 
 Battery may explode if mistreated. Do not 
recharge, disassemble or dispose of in fire.
 Dispose of the used battery promptly. Keep 
away from children.
Important Safety 
Instructions
1)  Read these instructions.
2)  Keep these instructions.
3)  Heed all warnings.
4)  Follow all instructions.
5)  Do not use this apparatus near water.
6)  Clean only with dry cloth.
7)  Do not block any ventilation openings. 
Install in accordance with the 
manufacturer’s instructions.
8)  Do not install near any heat sources such as 
radiators, heat registers, stoves, or other 
apparatus (including amplifiers) that 
produce heat.
9)  Do not defeat the safety purpose of the 
polarized or grounding-type plug. A 
polarized plug has two blades with one 
wider than the other. A grounding type plug 
has two blades and a third grounding prong. 
The wide blade or the third prong are 
provided for your safety. If the provided 
plug does not fit into your outlet, consult an 
electrician for replacement of the obsolete 
outlet.
10) Protect the power cord from being walked 
on or pinched particularly at plugs, 
convenience receptacles, and the point 
where they exit from the apparatus.
11) Only use attachments/accessories specified 
by the manufacturer.
12) Use only with the cart, stand, tripod, 
bracket, or table specified by the 
manufacturer, or sold with the apparatus. 
When a cart is used, use caution when 
moving the cart/apparatus combination to 
avoid injury from tip-over.
13) Unplug this apparatus during lightning 
storms or when unused for long periods of 
time.
14) Refer all servicing to qualified service 
personnel. Servicing is required when the 
apparatus has been damaged in any way, 
such as power-supply cord or plug is 
damaged, liquid has been spilled or objects 
have fallen into the apparatus, the apparatus 
has been exposed to rain or moisture, does 
not operate normally, or has been dropped.
For the state of california, USA only
Perchlorate Material –special handling may apply, 
See www.dtsc.ca.gov/hazardouswaste/
perchlorate
Perchlorate Material: Lithium battery contains 
perchlorate
Features
 Dual alarm FM/AM synthesized clock radio
 Nature Sound (Sea Waves, Birds, Rain, 
Brook, Under the Sea)
 Temperature display (Fahrenheit /
Centigrade) 5°F – 122°F (–15°C – 50°C)
 Built-in audio cable for Digital Music Player
 10 Station Presets (5 FM/5 AM)
 Various types of alarms - radio, buzzer and 
Nature Sounds (5)
 Automatic time set: when you plug the clock 
in for the first time, the current time will be 
shown in the display
 Automatic Daylight Savings Time Set/
Summer time adjustment
 100 year calendar and DATE/TIME ZONE 
button to display year, month and date
 Brightness Control (High/Low/Off)
 No Power No Problem alarm system to keep 
the clock and the alarm operating during a 
power interruption with a CR2032 battery 
installed
 Extendable Snooze system - Snooze time can 
be set from 10 to 60 minutes
 Progressive Alarm Speed (buzzer only)
Precautions
 Play the unit on the power source specified in 
“Specifications.”
 To disconnect the power cord (mains lead), 
pull it out by the plug, not the cord.
 Since a strong magnet is used for the speaker, 
keep personal credit cards using magnetic 
coding or spring-wound watches away from 
the unit to prevent possible damage from the 
magnet.
 Do not leave the unit in a location near a heat 
source such as a radiator or airduct, or in a 
place subject to direct sunlight, excessive 
dust, mechanical vibration, or shock.
 Allow adequate air circulation to prevent 
internal heat build-up. Do not place the unit 
on a thick pile surface (rug, a blanket, etc.), 
or near materials that might block the 
ventilation holes  (such as a curtain, etc.).
 Should any solid object or liquid fall into the 
unit, unplug the unit and have it checked by 
qualified personnel before operating it any 
further.
 To clean the casing, use a soft cloth 
dampened with a mild detergent solution.
 Never touch the wire of the external FM 
antenna during a thunderstorm. 
Furthermore, immediately disconnect the 
main plug from the wall outlet.
NOTES ON THE LITHIUM BATTERY
 Wipe the battery with a dry cloth to assure a 
good contact.
 Be sure to observe the correct polarity when 
installing the battery.
 Do not hold the battery with metallic 
tweezers, otherwise a short-circuit may 
occur.
If you have any questions or problems 
concerning your unit, consult your nearest 
Sony dealer.
Troubleshooting
Should any problem persist after you have 
made the following checks, consult your nearest 
Sony dealer.
The clock flashes 
“AM 12:00” due to a 
power interruption.
 The battery is low. Replace the battery. 
Remove the old battery and install a new one.
The alarm settings do not sound at the 
preset alarm time.
 Check that alarm “” or alarm “” is 
properly set/displayed.
The alarm settings are activated but there 
is no sound at the preset alarm time.
 Check the alarm volume setting.
When daylight saving time begins, the 
clock does not employ the daylight saving 
time automatically.
 Make sure the clock is set correctly.
 Press and hold DISPLAY/CLOCK and 
SNOOZE / BRIGHTNESS simultaneously for 
at least 2 seconds to activate the Automatic 
DST function.
Specifications
Time display
12-hour system
Radio section
Frequency range
Band Frequency
Channel step
FM
87.5 MHz – 108 MHz 0.1 MHz
AM
530 kHz – 1 710 kHz
10 kHz
General
Speaker
Approx. 3.6 cm (1 
7
/
16
 inches) dia. 8 Ω
Input
Built-in audio cable with stereo-mini plug 
(ø 3.5 mm)
Power output
0.7 W (at 10% harmonic distortion)
Power requirements
120 V AC, 60 Hz
For clock back up: 3V DC, one CR2032 battery
Nature Sound
Sea Waves, Birds, Rain, Brook, Under the Sea
Temperature range
5 °F – 122 °F (–15 °C – 50 °C)
Temperature resolution
1 °F (1 °C) 
Dimensions
Approx. 190 mm × 67 mm × 62 mm (w/h/d)  
(7 
1
/
2
 inches × 2 
3
/
4
 inches × 2 
1
/
inches) not 
including projecting parts and controls
Mass
Approx. 620 g (1 lb 5.87 oz) including power 
supply unit and CR2032 battery
Supplied accessories
AM loop antenna (1)
Design and specifications are subject to change 
without notice.
4-180-721-11(1)
About the backup 
battery
To maintain accurate time, this unit includes an 
internal CR2032 battery as a backup power 
source in the event of a power interruption.
Knowing when to replace 
the battery
When the battery becomes weak, “” will 
appear in the display.
If a power interruption occurs while the battery 
is weak, the current time and alarm will be 
initialized.
Replace the battery with a Sony CR2032 lithium 
battery. Use of another battery may cause a fire 
or explosion.
Note
If “AM 12:00” flashes in the display when the 
unit is connected to an AC outlet for the first 
time, the battery may be weak. In this case, 
consult your Sony dealer.
Installing and replacing the 
backup battery
1
  Keep the AC plug connected to the AC 
outlet, remove the screw that secures 
the battery compartment at the bottom 
of the unit using a screwdriver, and 
pull the battery compartment marked 
PULL OPEN. (See fig. -)
2
  Insert a new battery in the battery 
holder with the  side facing up.
To remove the battery from the battery 
compartment, push it out from the side 
marked PUSH. (See fig. -)
3
  Insert the battery compartment back 
into the unit and secure it with the 
screw.  
(See fig. -)
4
  When you are replacing the battery, 
press any of the following buttons: 
RADIO   BANDAUDIO IN, or 
NATURE SOUND / PRESET to turn 
“” off in the display.
Note
When you replace the battery, do not 
disconnect the AC plug from AC outlet. 
Otherwise, the 100 year calendar, current time, 
alarm and station presets will be initialized.
CR2032
Connecting the 
antenna
To connect the AM loop 
antenna
The shape and the length of the antenna is 
designed to receive AM signals. Do not 
dismantle or roll up the antenna.
1
  Remove only the loop part from the 
plastic stand.
2
  Set up the AM loop antenna.
3
  Connect the cords to the AM antenna 
terminals.
Cord (A) or cord (B) can be connected 
either way round.
A
B
Only insert up
to here.
Insert the cord while 
pushing down the 
terminal clamp.
4
  Make sure the AM loop antenna is 
connected firmly by pulling softly.
Adjusting the AM loop antenna
Find a place and an orientation that provides 
good reception.
 Do not place the AM loop antenna near the 
unit or other AV equipment, as noise may 
result.
Tip
Adjust the direction of the AM loop antenna for 
best AM broadcast sound.
©2010 Sony Corporation          Printed in China
FM/AM Clock Radio
ICF-C707
Operating Instructions
Dream Machine is a trademark of Sony Corporation.
No Power No Problem is a trademark of Sony Corporation.
This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset 
to EST (Eastern Standard Time) at the factory. And this battery is considered part of the product.