Sony BDV-N7200W Owner's Manual

Page of 84
65
US
BDV-N9200W/BDV-N7200W/BDV-N5200W
4-485-799-12(1)
D:\NORM'S JOB\SONY HA\SO130077\BDV-N9200_7200_5200_E3200 
(PMRF 01)\4485799121_US (U2)\100ADD.fm
masterpage:
Right
A
d
di
tio
n
al
 Inf
o
rm
at
io
n
Notes about Discs
On handling discs
• To keep the disc clean, handle the disc 
by its edge. Do not touch the surface.
• Do not stick paper or tape on the disc.
• Do not expose the disc to direct 
sunlight or heat sources such as hot air 
ducts, or leave it in a car parked in 
direct sunlight as the temperature 
may rise considerably inside the car.
• After playing, store the disc in its case.
On cleaning
• Before playing, clean the disc with a 
cleaning cloth.
Wipe the disc from the center out.
• Do not use solvents such as benzine, 
thinner, commercially available 
cleaners, or anti-static spray intended 
for vinyl LPs.
This system can only play a standard 
circular disc. Using neither standard nor 
circular discs (e.g., card, heart, or star 
shape) may cause a malfunction.
Do not use a disc that has a 
commercially available accessory 
attached, such as a label or ring.
Troubleshooting
If you experience any of the following 
difficulties while using the system, use 
this troubleshooting guide to help 
remedy the problem before requesting 
repairs. Should any problem persist, 
consult your nearest Sony dealer.
In the event of a problem with the 
wireless sound function, have a Sony 
dealer check the entire system (main 
unit and surround amplifier).
The power does not turn on.
t Check that the AC power cord 
(mains lead) is connected securely.
The remote control does not function.
t The distance between the remote 
control and the main unit is too far.
t The batteries in the remote control 
are weak.
The disc lid does not open and you 
cannot remove the disc even after you 
press Z.
t Try the following:
1
Press and hold N and Z on the 
main unit for more than 
5 seconds to open the disc lid.
2
Remove the disc.
3
Disconnect the AC power cord 
(mains lead) from the wall outlet 
(mains), then reconnect after 
several minutes.
The system does not work normally.
t Disconnect the AC power cord 
(mains lead) from the wall outlet 
(mains), then reconnect after 
several minutes.
General