Alpine CDE-SXM145BT Owner's Manual
43
-EN
Installation
CAUTION
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.
1
Remove the mounting sleeve from the main unit (Refer to
“Removal” on page 43).
“Removal” on page 43).
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
Reinforce the head unit with the metal mounting strap
(not supplied). Secure the ground lead of the unit to a
clean metal spot.
(not supplied). Secure the ground lead of the unit to a
clean metal spot.
Connect each input lead coming from an amplifier to the
corresponding output lead coming from the left rear of the
CDE-SXM145BT/CDE-143BT/UTE-42BT. Connect all other leads
of the CDE-SXM145BT/CDE-143BT/UTE-42BT according to
details described in the CONNECTIONS section.
corresponding output lead coming from the left rear of the
CDE-SXM145BT/CDE-143BT/UTE-42BT. Connect all other leads
of the CDE-SXM145BT/CDE-143BT/UTE-42BT according to
details described in the CONNECTIONS section.
Note
• For the screw marked “
*
”, use an appropriate screw for the chosen
mounting location.
3
Slide the CDE-SXM145BT/CDE-143BT/UTE-42BT into the
dashboard until it clicks. This ensures that the unit is
properly locked and will not accidentally come out from
the dashboard. Install the detachable front panel.
dashboard until it clicks. This ensures that the unit is
properly locked and will not accidentally come out from
the dashboard. Install the detachable front panel.
1
Remove the detachable front panel.
2
Insert the bracket keys into the unit, along the guides on
either side. The unit can now be removed from the
mounting sleeve.
either side. The unit can now be removed from the
mounting sleeve.
3
Pull the unit out, keeping it unlocked as you do so.
JAPANESE CAR
Mounting the Microphone
For the sake of safety, mount the microphone in the following location.
• In a stable and secure location.
• In a location that does not inhibit safely driving the vehicle.
• Mount the microphone in a location where the driver’s voice can
• In a stable and secure location.
• In a location that does not inhibit safely driving the vehicle.
• Mount the microphone in a location where the driver’s voice can
easily be picked up.
Choose a location for the microphone that can easily pick up the drivers
voice. Requiring the driver to move towards the microphone for
audibility causes a distraction that could be dangerous.
voice. Requiring the driver to move towards the microphone for
audibility causes a distraction that could be dangerous.
Detachable Front
Panel
Panel
Less than 35°
Dashboard
Mounting Sleeve (Included)
Pressure Plates*
This unit
*
Bolt Stud
Hex Nut (M5)
Metal
Mounting
Strap
Mounting
Strap
Screw
This unit
Removal
Bracket keys
(Included)
(Included)
This unit
Front Frame
Screws (M5 × 8)
(Included)
(Included)
This unit
Mounting Bracket