Whirlpool WEE730H0DS Installation Instruction

Level Range

1. Place level on the oven bottom as indicated in one of the two

figures below depending on the size of the level. Check with
the level side to side and front to back.

2. If range is not level, use a wrench or pliers to adjust leveling

legs up or down until the range is level.

NOTE: Range must be level for satisfactory baking
performance and best cleaning results using AquaLift

Self-Clean Technology.

Electrical Connection - U.S.A. Only

If your home has a 3- or 4-wire receptacle, continue with “Install
Using a Power Supply Cord.” If your home has a 3- or 4-wire
direct connection, go to “Install Using Direct Wire.”

Install Using a Power Supply Cord

Power supply cord strain relief

1. Disconnect power.

2. Remove the lower access cover screws located on the back

of the range. Pull the bottom of the cover toward you and out
to remove cover from range.

3. Remove plastic tag holding three 10-32 hex nuts from the

middle post of the terminal block.

4. Assemble a UL listed strain relief in the opening.

5. Complete installation following instructions for your type of

electrical connection:

4-wire (recommended)

3-wire (if 4-wire is not available)

Electrical Connection Options

A. Three mounting tabs
B. Lower access cover

C. Screws (2)

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Use a new 40 amp power supply cord.

Plug into a grounded outlet.

Failure to follow these instructions can result in death,
fire, or electrical shock.

A. UL listed strain relief

If your home has:

And you will be
connecting to:

Go to Section:

3-wire receptacle
(NEMA type 10-50R)

A UL listed,
250-volt
minimum,
40- or 50-amp,
range power
supply cord

3-wire connection:
Power supply cord

4-wire receptacle
(NEMA type 14-50R)

A UL listed,
250-volt
minimum,
40- or 50-amp,
range power
supply cord

4-wire connection:
Power supply cord